Simx Lighting LHT1131 2 x 6W LED Up-Down Lights Instruction Manual
- June 13, 2024
- Simx Lighting
Table of Contents
**INSTALLATION INSTRUCTIONS
2 x 6W LED Up/Down Lights
LHT1131 ANTHRACITE
LHT1177 BLACK
1 x 7W LED Downlights
LHT1132 ANTHRACITE
LHT1178 BLACK**
The Simx Lighting Ruapehu Up/Down Lights and Downlights are contemporary designs with high quality LED luminaires. Water and dustproof, they are rated for exposed exterior locations.
TECHNICAL SPECIFICATIONS
| Voltage | 220-240V AC |
|---|---|
| Lumens | 2 x 6W: 950 lm |
1 x 7W: 500 lm
LED Colour| Warm White 3000K
IP Rating| IP65
Safety| Class I
Mounting| Wall
Construction| Powder Coated Aluminium / Tempered Glass
BEFORE YOU START
Please read all the instructions prior to installation.
The Ruapehu light should be wired to its own light switch.
Do not connect with other lamp types on the same switch.
An earth connection must be used for electrical safety.
For all locations, please check that the direction of the beam will not cause
undue glare to neighbouring properties.
IMPORTANT
This product is suitable for use only with a supply voltage of 220-240V AC
50Hz.
All electrical work must be carried out in accordance with local and national
electrical codes as applicable.
We strongly recommend that this light fitting is installed by a registered
electrician.
Always switch power off prior to installation. A means of mains power
isolation must be installed in the circuit for the purpose of safe access for
any internal cleaning, recalibration, or maintenance.
This light fitting is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Young children
should be supervised to ensure that they do not play with the appliance.
Any changes or modifications made or attempted to this product, without the
prior written approval of the manufacturer, will void any and all stated
warranties.
INSTALLATION
We strongly recommend this light fitting is installed by a registered electrician. This guide can be used to install both models listed in this manual.
-
Switch off the power supply before commencing any electrical work.
-
Unscrew the fixing cover screws with the allen key supplied and remove the rear mounting base.
-
Use the rear base to mark the position of screw holes onto the mounting surface. Use a spirit level to ensure correct orientation.
-
Drill the wall to depth of about 40mm and fit the wall plugs (supplied). Care should be taken to avoid drilling or screwing into concealed electrical wiring/plumbing.
-
Push the power supply through the cable gland.
Affix the rear base to the mounting surface with mounting wall screws supplied. To maintain the IP rating, a round 3 core 0.75mm² (min) cable should be used. -
Connect the power cables to the terminal block securely using the wiring diagram in Step 7.
-
Terminate the power supply cable.
-
Reattach and screw securely the cover to the base.
Ensure cables are not pinched when closing the unit. -
Reconnect mains power and test circuit.
PRODUCT COMPLIANCES
Product complies with:
Ruapehu LED lights comply with all applicable standards.
MANUFACTURERS EXTENDED WARRANTY
This product is guaranteed by SIMX Ltd and Ventair Pty Ltd for 5 years from
the date of purchase against faulty materials or workmanship which affects its
designed ability to switch and operate. During this period if the product has
a defect of this nature it will be repaired or replaced free of charge by SIMX
with the same item, or a similar one of higher specification.
ON CONDITION THAT:
- The buyer returns it to the seller from whom it was bought, freight paid.
- The product has been bought by the user (ie. a receipt/sales invoice is produced as proof of purchase).
- The product has not been misused or handled carelessly, installed in any way contrary to the installation instructions, or installed in any unusually exposed or harsh environmental conditions.
This guarantee excludes liability for discolouration of paint or plastic, or
any user serviceable parts.
It does not confer any rights other than those expressly set out above and
does not cover any claims for consequential loss or damage.
Our Goods come with guarantees that cannot be excluded under either
Australian, or New Zealand, Consumer Law.
You are entitled to a replacement or refund for a major failure and for
compensation for any other reasonably foreseeable loss or damage. You are also
entitled to have the Goods repaired or replaced if the Goods fail to be of
acceptable quality and the failure does not amount to a major failure.
Specifications are subject to change without notice
Distributed in New Zealand by Simx Ltd
Ph: +64 9 259 1660 | Technical Support Ph: +64 9 259 1662
e: [email protected] |
www.simx.co.nz
Distributed in Australia by Ventair Pty Ltd
4 Capital Place, Carrum Downs, 3201 VIC, AUSTRALIA.
Technical Support: 1300 665 926
e: [email protected] |
www.ventair.com.au
PUB1565 2204