Hukoro F88702-11I Outdoor Wall Light Instruction Manual
- October 30, 2023
- Hukoro
Table of Contents
Hukoro F88702-11I Outdoor Wall Light
Product Information
The light fixture is a lighting product that requires assembly and installation. It includes a mounting unit, fixture, ball nuts, rubber rings, mounting screws, wire nuts, and hardware for installation. The product requires tools such as a ladder, safety glasses, electrical Phillips screwdriver, flat blade screwdriver, pliers, and wire strippers for assembly and installation.
Product Usage Instruction
Assembly Instructions
Before assembling or installing the light fixture, ensure that the fuse at
the fuse box is removed. Follow the below instructions to assemble the light
fixture:
Attach Mounting Unit
- Unscrew the ball nuts from the mounting unit.
- Use the mounting screws to attach the mounting unit to the junction box.
Make Electrical Connection
- Connect the ground wire to the mounting unit using the preinstalled green ground screw.
- Connect the positive, negative, and ground wires from the junction box to the fixture using the supplied wire nuts.
- Secure with electrical tape.
Attach Fixture
- Attach the fixture to the mounting unit through screw holes as shown.
- Secure it with rubber rings and ball nuts.
- Apply caulk in the backplate and wall mounting surface to prevent water from entering.
Install Bulb
Install a bulb (not included) in the fixture.
Note:
The parts shown in the manual may differ slightly per light fixture.
By following these instructions, you can assemble and install the light fixture and enjoy its benefits.
CAUTION
- Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
- Before starting the installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
TOOLS REQUIRED
HARDWARE INCLUDED
PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
EXPLODED PARTS
INSTALLATION
-
STEP 1
Unscrew the ball nuts from the mounting unit. Use the mounting screws to attach the mounting unit to the junction box.
-
STEP 2
Make the electrical connection from the junction box to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative and ground wires with the supplied wire nuts. Secure with electrical tape.
-
STEP 3
Attach the fixture to the mounting unit through screw holes as shown, and secure it with rubber rings and ball nuts.
NOTICE: Please use caulk in the back plate and wall mounting surface to prevent water from entering.
-
STEP 4
Attach the fixture to the mounting unit through screw holes as shown, and secure it with rubber rings and ball nuts.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>