Hukoro F17711-BK-S 1 Light 17.25 Inch H Matte Black Outdoor Wall Lantern Instruction Manual
- October 30, 2023
- Hukoro
Table of Contents
Hukoro F17711-BK-S 1 Light 17.25 Inch H Matte Black Outdoor Wall Lantern
Product Information
The product is a light fixture that requires assembly and installation. The package includes a mounting unit, fixture, ball nuts, rubber rings, mounting screws, wire nuts, and exploded parts. The product requires tools such as a ladder, safety glasses, electrical screwdriver, Phillips screwdriver, flat blade screwdriver, pliers, and wire strippers for assembly and installation. The product requires a junction box (not included) for installation.
Product Usage Instructions
- Unscrew the rubber rings and ball nuts from the mounting unit. Use the mounting screws to attach the mounting unit to the junction box (not included).
- Make the electrical connection from the junction box (not included) to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative, and ground wires with the supplied wire nuts. Secure with electrical tape.
- Attach the fixture to the mounting unit through screw holes as shown, and secure it with rubber rings and ball nuts. Use caulk in the back plate and wall mounting surface to prevent water from entering.
- Install a bulb (not included) in the fixture.
Note: If you need further assistance with assembly or installation, please contact us by email at customersupport@superiordecorinc.com. Also, before starting the installation process, it is recommended to remove the fuse at the fuse box to ensure safety.
CAUTION
- Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
- Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
TOOLS REQUIRED
HARDWARE INCLUDED
EXPLODED PARTS
INSTALLATION
-
Unscrew the rubber rings and ball nuts from the mounting unit. Use the mounting screws to attach the mounting unit to the junction box (not included).
-
Make the electrical connection from the junction box (not included) to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative and ground wires with the supplied wire nuts. Secure with electrical tape.
-
Attach the fixture to the mounting unit through screw holes as shown, and secure it with rubber rings and ball nuts.
NOTICE: Please use caulk in the back plate and wall mounting surface to prevent water from entering.
-
Install bulb (not included).
If you need further assistance, please contact us by Email: customersupport@superiordecorinc.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>