Hukoro F89622-QC Incandescent Flush Mount Light Instruction Manual
- October 30, 2023
- Hukoro
Table of Contents
Hukoro F89622-QC Incandescent Flush Mount Light
ASSEMBLY INSTRUCTIONS
CAUTION
- Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
- Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
If you need further assistance, please contact us by Email: customersupport@superiordecorinc.com
TOOLS REQUIRED
-
Ladder
-
**Safety glasses
**
- **Electrical tape
**
-
Phillips screwdriver
-
Flat blade screwdriver
-
Pliers
-
Wire strippers
HARDWARE INCLUDED
- **Fixture
**
-
Glass Shade
-
Hex Nut
-
Cap
-
Mounting Screws
-
Mounting Unit
-
Wire Nuts
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
EXPLODED PARTS
INSTALLATION
STEP 1
Use the mounting screws to attach the mounting unit to the junction
box (not included).
STEP 2
Disassemble the glass shade under the fixture by unscrewing hex nut
and cap.
STEP 3
Make the electrical connection from the junction box (not included) to the
fixture.
Connect the ground wire to the mounting unit using the preinstalled green
ground screw.
Next, connect the positive, negative and ground wires with the supplied
wire nuts.
Secure with electrical tape.
STEP 4
Attach the fixture to the mounting unit by inserting two fixture
screws and rotating the fixture until it locks in place.
Then tighten the fixture screws securely.
STEP 5
Install bulb (not included)
STEP 6
Place the glass shade onto the fixture, then secure with hex nut and
cap.
Documents / Resources
|
Hukoro F89622-QC Incandescent Flush Mount
Light
[pdf] Instruction Manual
F89622-QC, F89622-QC Incandescent Flush Mount Light, Incandescent Flush Mount
Light, Flush Mount Light, Mount Light, Light
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>