Hukoro 76382-QC Flush Mount Ceiling Light Installation Guide
- October 30, 2023
- Hukoro
Table of Contents
ASSEMBLY INSTRUCTIONS
CAUTION
- Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
- Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
TOOLS REQUIRED
HARDWARE INCLUDED
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
EXPLODED PARTS
INSTALLATION
STEP 1
Use the mounting screws to attach the mounting unit to the junction
box.
ASSEMBLY INSTRUCTIONS (INSTALLATION)
STEP 2 Make the electrical connection from the junction box to the
fixture.
Connect the ground wire to the mounting unit using the preinstalled green
ground screw. Then, connect the positive, negative and ground wires with the
supplied wire nuts. Secure with electrical tape.
STEP 3
Attach the fixture to the mounting unit by inserting two fixture screws and
rotating the fixture until it locks in place.
Then tighten the fixture screws securely.
STEP 4
Screw the threaded pipe and hex nut into the fixture, then secure it with hex
nut.
STEP 5
Install bulb (not included)
STEP 6
- Remove the two hex nuts A ,washer and rubber ring from the threaded pipe and hex nut.
- Place the glass shade, rubber ring and washer onto the threaded pipe and hex nut, then secure with hex nut A.
STEP 7
Place the cage onto the threaded pipe and hex nut, then secure with hex nut A.
STEP 8
Place the cap onto the threaded pipe and hex nut, then secure with decorative
nut .
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>