Hukoro F75451-QC 1-Light Outdoor Wall Light Installation Guide
- October 30, 2023
- Hukoro
Table of Contents
Hukoro F75451-QC 1-Light Outdoor Wall Ligh
Product Information
The product is a light fixture that requires assembly and installation. The package includes a Fixture, Glass Shade, Cage, Screws, Ball Nut, Mounting Unit, Wire Nuts, and Mounting Screws. The product requires several tools for installation, including a ladder, safety glasses, electrical Phillips screwdriver, flat blade screwdriver, pliers, wire strippers, and tape. The product has an exploded parts diagram to assist with assembly. The product requires an electrical connection to the junction box, including a black or red wire (hot) from the junction box, white wire (neutral) from the junction box, and bare or green ground wire from the junction box. The fixture also has a black wire, white wire, and ground wire. The product requires bulbs (not included) for use.
ASSEMBLY INSTRUCTIONS
CAUTION
- Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
- Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
TOOLS REQUIRED
HARDWARE INCLUDED
- PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
EXPLODED PARTS
INSTALLATION
-
1. Unscrew the ball nut from the mounting unit. Use the mounting screws to attach the mounting unit to the junction box. -
Make the electrical connection from the junction box to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative and ground wires with the supplied wire nuts. Secure with electrical tape.
-
Secure the fixture to the mounting unit with the ball nut.
NOTICE: Please use caulk in the back plate and wall mounting surface to prevent water from entering. -
Install bulb (not included)
-
Attach the glass shade and cage onto fixture using screws.