Hukoro F78152-QC 2 Light 14 Inch Modern Style Semi Flush Mount Instruction Manual

Hukoro F78152-QC 2 Light 14 Inch Modern Style Semi Flush Mount

Product Information

The product is a light fixture that comes with all the necessary hardware for installation. The hardware includes the fixture, glass shade, threaded pipe and hex nut, washer, rubber ring, cap, ball nuts, mounting screws, and mounting unit wire nuts. The product requires assembly and the user must have a ladder, safety glasses, electrical Phillips screwdriver, flat blade screwdriver, pliers, and wire strippers. The product is designed for indoor use only.

Product Usage Instructions

1. Use the mounting screws to attach the mounting unit to the junction box.
2. Make the electrical connection from the junction box to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative and ground wires with the supplied wire nuts. Secure with electrical tape.
   • The black or red wire (hot) from the junction box should be connected to the black wire from the fixture.
   • The white wire (neutral) from the junction box should be connected to the white wire from the fixture.
   • The bare or green ground wire from the junction box should be connected to the ground wire from the fixture.
3. Attach the fixture to the mounting unit by inserting two fixture screws and rotating the fixture until it locks in place. Then tighten the fixture screws securely.
4. Screw the threaded pipe and hex nut into the fixture, then secure it with hex nut.
5. Install bulb (not included).
6. Place the washer, rubber ring, glass shade and cap onto the threaded pipe and hex nut, then secure with ball nut.

Caution: Before starting any installation, make sure to turn off the power supply by removing the fuse at the fuse box. Always wear safety glasses when installing the product. If you are unsure about any part of the installation process, consult a licensed electrician.

ASSEMBLY INSTRUCTIONS

• Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
• Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.

TOOLS REQUIRED

HARDWARE INCLUDED

*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE

EXPLODED PARTS

INSTALLATION

STEP 1
Use the mounting screws to attach the mounting unit to the junction box

STEP 2
Make the electrical connection from the junction box to the fixture.
Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative and ground wires with the supplied wire nuts. Secure with electrical tape.

STEP 3
Attach the fixture to the mounting unit by inserting two fixture screws and rotating the fixture until it locks in place. Then tighten the fixture screws securely.

STEP 4
Screw the threaded pipe and hex nut into the fixture, then secure it with hex nut.

STEP 5
Install bulb (not included)

STEP 6
Place the washer, rubber ring, glass shade and cap onto the threaded pipe and hex nut, then secure with ball nut.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>