Hukoro 2F19051-BK-S 1-Light 18-in Matte Outdoor Wall Light Instruction Manual
- October 30, 2023
- Hukoro
Table of Contents
Hukoro 2F19051-BK-S 1-Light 18-in Matte Outdoor Wall Light Instruction Manual
ASSEMBLY INSTRUCTIONS
⚠ CAUTION
- Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
- Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by
removing the fuse at the fuse box.
If you need further assistance, please contact us by Email: [email protected]
TOOLS REQUIRED
HARDWARE INCLUDED
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
EXPLODED PARTS
INSTALLATION
STEP 1
Unscrew the rubber rings and ball nuts from the mounting unit. Use the
mounting screws to attach the mounting unit to the junction box (not
included).
STEP 2
Make the electrical connection from the junction box (not included) to the
fixture. Connect the ground wire to the mounting unit using the preinstalled
green ground screw. Then, connect the positive, negative and ground wires with
the supplied wire nuts. Secure with electrical tape.
STEP 3
Attach the fixture to the mounting unit through screw holes as shown, and
secure it with rubber rings and ball nuts.
NOTICE : Please use caulk in the back plate and wall mounting surface to prevent water from entering.
STEP 4
Install bulb (not included)
