rutec 80790-V2 DALI-2 Dimm-Actor Instruction Manual
- June 9, 2024
- rutec
Table of Contents
rutec 80790-V2 DALI-2 Dimm-Actor
PRODUCT DIMENSIONS
DIP switches setting options
PN(W) (max. power) | 50 W | 0.93 | ||
---|---|---|---|---|
UN(V) (input voltage ) | (200-240)V AC | tc | 75 | |
IN(mA) (input current ) | 270 | ta | -20~45 | |
fN(Hz) | 50/60 | Uo | 8-52 V | |
Io | 350 mA | 450 mA | 500 mA | 600 mA |
Uo | 8-52 V | 8-52 V | 8-52 V | 8-52 V |
Io | 950 mA | 1050 mA | 1100 mA | 1200 mA |
--- | --- | --- | --- | --- |
Uo | 8-52 V | 8-47 V | 8-45 V | 8-41 V |
WIRING DIAMETER
OPERATING INSTRUCTIONS
Please install the DALI-2 dimming actuator as shown in the wiring diagram
above. Before connect the LEDs, please set the desired current range using the
DIP switch.
Setting the dali addresses
-
Automatic setting
The DALI-2 master unit assigns the addresses automatically. The function can be found in the manual of the of the master. -
push-dim
As soon as the terminals Da+(L’) and Da-(N) have been connected to the 230 V AC push-button, the operating mode changes to push dim.- Pressing briefly switches the outputs On/Off.
- Pressing and holding dims the light strip to the desired brightness value.
- Press and hold again to dim the continuous row.
- The dimming range is 1-100 %.
SAFETY INSTRUCTIONS
- Be sure to have a professional electrician complete installation. There is no warranty coverage for any lights installed without observing european safety directives.
- The LED controller is not waterproof. Please protect the controller from direct sunlight and avoid rain. For outdoor installation, please ensure that the controller is installed in a waterproof housing.
- Always ensure that the unit is installed in a location with good ventilation to ensure correct operating temperature.
- Check that the voltage and the power adapter are suitable for the controller and that the designation of the anode and cathode matches those of the controller.
- Please ensure that an appropriate cable diameter is used for the connection between the controller and the LED.
- Never connect the cables when the power is on, check that the connections are correct and check for short circuits before switching on the power.
- Please do not carry out any repairs yourself. This will invalidate the manufacturer’s warranty.
To further upgrade your suspension, use other QA1 suspension products such as coil-overs, shocks, struts, springs, K-members, torque arms, panhard rods, sub-frame connectors, strut tower braces, rod ends, sway bars, tubular control arms, spherical bearings, carbon fiber driveshafts and more. For more information, please visit www.QA1.net
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>