rutec REACH25 LED Strip Instructions

June 4, 2024
rutec

Standard IP67 REACH25

The LED strip is suitable for installation in dry and wet interiors as well as outdoors.
Risk of electric shock!
Be sure to have a professional electrician complete the installation. There is no warranty coverage for any lights installed without observing European safety directives.
Caution!
Only connect the LED strip to a suitable power supply (24 V DC).
Only operate when completely unrolled.
Connect LED strips in parallel.
Connect
LED strips in parallel.
Scope of delivery
1 x 25 meter
LED strip
4 x end cap
4 x feeder cap
1 x 150 mm connection cable
100 x holder

Technical data

Power supply 24 V power supply with constant output voltage
Power 100 W
Current strength 4.17 A
Beam angle 120°
Quantity LED 1500
Length maximum 25 meters per connection
Dimensions 25000 x 12 x 6 mm
Bending diameter 120 mm
Compliant with the applicable european CE directives
--- ---
Safety class 3 – low voltage protection
not uv-resistent

Please refer to the respective article onwww.rutec.de for complete technical data! 

Installation

Risk of electric shock!
Switch off voltage prior to installation. Ensure that voltage cannot be accidentally switched on again.
Caution! On conducting surfaces, place an insulation layer between the LED strip and surface. Surfaces must be flat, free of dust, grease and dry.

  1.  Prepare surface.
  2. Shorten the LED strip if necessary (Fig. 1).
  3. Mount LED strip with help of included holder in a distance of ~25-30 cm without pressing onto electronic components.
  4. Connect LED strip to the power supply.

Shortening the LED strip

Risk of electric shock!
Always disconnect the mains plug before shortening. LED strip can be separated in each case after six LEDs (100 mm) (Fig. 1).

rutec REACH25 LED Strip - figSeparate the LED strip at the marked position.
For a tightly assembled LED strip is a micro side cutter or an optional cutter required. Glue the end cap with neutral cross-linking silicone at the end of the separation point.
Caution!
With soldered connections note that the soldering temperature is 260° C and the soldering duration a maximum of 10 seconds per soldering point. Only use neutral cross-linked silicon (never use silicon that includes vinegar!).

Connection:

  1. Fix a two-wired stranded connection cable with the help of lead-free solder to the soldering contacts of the separation point in compliance with the above-mentioned soldering temperature indication.
  2. Close open silicone tube ends with neutral cross-linking silicone.

rutec REACH25 LED Strip - fig 1

Disposal
Dispose of electrical and electronic equipment in an environmentally friendly manner. Please contact your local council for further information.

Standard IP67REACH25_BA_86550_10/2021
Carl-Zeiss-Str. 15 **
28857 Syke**

Documents / Resources

| rutec REACH25 LED Strip [pdf] Instructions
REACH25 LED Strip, REACH25, LED Strip
---|---

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals