rutec 83445 350mA LED Converter Instruction Manual
- June 13, 2024
- rutec
Table of Contents
LED converter 350mA 4-10W
83445
INSTRUCTIONS FOR USE
SAFETY INSTRUCTIONS
General notes for installation
- Commission a qualified electrician to carry out the installation.
- Always ensure that the unit is installed in a location with good ventilation to ensure the correct operating temperature.
- Never connect the cables when the unit is switched on.
- Check the correctness of the connections and check for short circuits before switching on the voltage.
- Please do not carry out any repairs yourself. This will invalidate the manufacturer‘s warranty.
FOR THE INSTALLATION SITE AND THE PRODUCT MUST BE TAKE INTO ACCOUNT
The product is suitable for indoor and outdoor use.
The permissible ambient temperature for the product is -25° C to + 45° C.
Improper use will destroy the product and we will not accept any guarantee.
Therefore, please observe our assembly instructions.
TOOLS REQUIRED
The following tools are required for mounting the LED power supply unit:
- Drilling machine with various stone and HSS drills
- Cordless screwdriver with various bit sets
- Screws, dowels
- Hammer, screwdriver etc.
DISPOSAL
Dispose of electrical and electronic equipment in an environmentally sound
manner. For more information, contact your local authority.
TECHNICAL DATA:
Input:
220 – 240 V AC, 50/60 Hz
Output:
350 mA, 8.5-28 V DC, 3-9.8 W (without dimming)
350 mA, 12-28 V DC, 4,2-9.8 W (with dimming, LC)
Ambient temperature:
-25 to +45° C
Psb:
0.00
Pno:
0.65
Efficiency at full load:
82 %
Tolerance:
± 8 %
Not suitable for no-load condition
TECHNICAL PRODUCT DIMENSIONS
Length x width x height ( L x W x H )
102.0 mm x 38.0 mm x 21.0 mm
Power supply units per circuit breaker
| CBR | B10 | B16 | B25 | C10 | C16 | C25 |
|---|---|---|---|---|---|---|
| Pcs. | 31 | 50 | 78 | 52 | 85 | 130 |
The LED converter 83445 is a dimmable converter on the primary side, which outputs a rectified constant current of 350 mA DC and a maximum power of 10 W on the secondary side.
WIRING DIAGRAM:
INSTALLATION:
- First connect the LED module to the secondary side of the LED converter unit. Pay attention to the correct polarit + (anode) and – (cathode).
- Connect the primary side of the LED power supply unit to the 230 V AC mains voltage in a voltage-free state.
- Check that the input and output cables have been connected correctly before switching on the power to operate the LED power supply.
INSTALLATION NOTE:
We recommend a flexible cable with a maximum ring circuit length of 16.0 m for
the secondary side.
NOTES:
Carl-Zeiss-Str. 15 28857 Syke … auf lange Sicht!
LED-Konverter 350mA_4-10W_83445_MA_06/2023
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>