rutec 87643 48V LED Power Supply User Manual

June 1, 2024
rutec

LED power supply 48V, 150W IP67
87643

rutec 87643 48V LED Power Supply

MOUNTING AND OPERATING INSTRUCTIONS

rutec 87643 48V LED Power Supply - Symbol 1

IMPORTANT SAFETY-/ INSTALLATION INSTRUCTIONS:

Allgemeine Hinweise zur Inbetriebnahme General notes for installation

  • Commission a qualified electrician to carry out the installation.
  • Always ensure that the unit is installed in a location with good ventilation to ensure the correct operating temperature.
  • Never connect the cables when the unit is switched on.
  • Check the correctness of the connections and check for short circuits before switching on the voltage.
  • Please do not carry out any repairs yourself. This will invalidate the manufacturer‘s warranty.

FOR THE INSTALLATION SITE AND THE PRODUCT MUST BE TAKE INTO ACCOUNT:
The product is only suitable for indoor and outdoor use.
The permissible ambient temperature for the product is -40 to +50° C.
Improper use will destroy the product and we will not accept any guarantee.
Therefore, please observe our assembly instructions.

POWER SUPPLY UNITS PER CIRCUIT BREAKER:

LS B10 B16 B25 C10 C16 C25
Stk. 1 2 3 2 3 5

TECHNICAL DATA:

Inpu: 220-277V AC, 50/60Hz, 186-250V DC
Output: 48V DC, 148.8W max.
Ambient temperature -40 bis +50°C
Psb: 0.00 W
Pno: 1 W
Efficiency at full load: 89%
Tolerance: ±3 %

TECHNICAL PRODUCT DIMENSIONS:

Dimensions (L x W x H):
188 x 68 x 33,5 mm

rutec 87643 48V LED Power Supply - Dimensions

MARKS AND SYMBOLS:

**** CE-compliant with the applicable European directives
RoHS mark for products that do not contain heavy metals (EC Directive

2002/95/EC)
| REACH test mark for products whose chemical components are known, registered and authorised (1907/2006/EG)
| Parallel connection Suitable for through-wiring.
| Independent operating device
| Safety transformer, short-circuit proof
| Safety extra-low voltage
| Protection class I
(protective conductor connection)
|  Protected against temporary
submersion

DISPOSAL:
**** Dispose of electrical and electronic equipment in an environmentally sound manner. For more information, contact your local authority.

DESCRIPTION:

GENERAL INFORMATION:
The LED power supply unit 87643 is a non-dimmable power supply on the primary side, which outputs a rectified constant voltage of 48V DC on the secondary side for a maximum power consumption of 148.8W.

WIRING DIAGRAM:

rutec 87643 48V LED Power Supply - WIRING DIAGRAM

INSTALLATION:

  • First connect the LED strip to the secondary side of the power supply unit. Pay attention to the correct polarity + (anode) and – (cathode).
  • Connect the primary side of the LED power supply unit to the 230 V AC mains voltage in a de-energised state, observing the five safety rules.
  • Check that the input and output cables have been connected correctly before switching on the power to operate the LED power supply.

INSTALLATION NOTE:
We recommend a flexible cable and a maximum connection length of 4.0 m for the secondary connection.
With a longer connection cable, design the cross-section of your cable so that the expected voltage drop is ≤0.2V DC to prevent a brightness or colour shift in the LED strip.

Carl-Zeiss-Str. 15
28857 Syke
*powered by uPower Tek

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals