SATCO NUVO 0-10V BLINK LED Flush Mount Light Instruction Manual

: June 3, 2024
: SATCO

Table of Contents

SATCO NUVO 0-10V BLINK LED Flush Mount Light
Safety recommendations
Specifications
INSTALLATION
Dimming
Cleaning
5 Year limited warranty
customer service
Satco Products Inc.
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SATCO NUVO 0-10V BLINK LED Flush Mount Light

SATCO-NUVO-0-10V-BLINK-LED-Flush-Mount-PRODUCT

Thank you for purchasing our product. This fixture has been manufactured from components with advanced optoelectronics to ensure high reliability and long life. Before assembling please read this Operation Manual carefully and save in a safe place for future reference. Please note that all electrical connections must be in accordance with local and National Electrical Code standards as well as local building codes. In case you are not familiar with proper wiring connections and building codes, consult a qualified electrician.

Safety recommendations

RISK OF ELECTRIC SHOCK – THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH APPLICABLE INSTALLATION CODES BY A PERSON FAMILIAR WITH MENTIONED ABOVE CODES AND HAZARDS INVOLVED. DISCONNECT POWER AT CIRCUIT BREAKER OR FUSE BEFORE INSTALLING OR SERVICING.
BEFORE USE OF THE PRODUCT CAREFULLY READ THE WHOLE INSTALLATION INSTRUCTIONS.
THE PRODUCT IS SUITABLE FOR BOTH: DAMP AND WET LOCATIONS.
ASSEMBLE THE PRODUCT ONLY WITH THE USE OF PARTS PROVIDED AND THE HOUSING;
IMPROPER ASSEMBLY MAY RESULT IN DEVICE FAILING WHICH COULD DAMAGE THE PRODUCT, PERSONAL PROPERTY OR CAUSE INJURY.
ASSEMBLY SHALL FOLLOW WITH ACCESSORIES DELIVERED WITH THE SET ONLY. THE DEVICE IS NOT A TOY, KEEP OUT OF REACH OF CHILDREN.

Specifications

Operating Voltage: 120VAC
Dimming: 0-10V
Life span: 50,000h

INSTALLATION

SATCO-NUVO-0-10V-BLINK-LED-Flush-Mount-FIG-1

STEP 1: Turn-off/disconnect power at the circuit braker. Attach orange connector (provided) to AC cable from junction box: L side to Black side wire. N side to White AC wire.
STEP 2: Attach the bracket to junction box using 2 screws (provided). Pull the AC cable with connector through the bracket center hole.
STEP 3: Make ground and dimming connection using wire nuts (provided). Next simply ‘click’ the two sides of orange connector together.
STEP 4: Aling slots on the edge of fixture with the Pressure Clips on the mounting bracket and PUSH to lock fixture in place.
STEP 5: Push and feed all wires up into junction box as you raise the fixture into place. For wet location usage, please caulk the edge of the fixture with glue to ceiling.

Dimming

This product is compatible with most 0-10V dimming controls available on the market. Dimming performance will depend on the type and brand of dimmer and dimmer settings. Visit satco.com for an up to date list of compatible dimmers.

Cleaning

Clean with a soft or damp cloth. While cleaning with the damp cloth make sure the power is off.
Do not clean with abrasives.

5 Year limited warranty

The purchased product is covered with a 5 year warranty in respect of any defect in material or workmanship after purchase date. Satco shall bear no responsibility on account of guarantee, as well as shall bear no liability for any faults, in case of improper operation, use negligence, accident or exposure to natural hazard, or excessive use over the limits specifed for the unit, or if any unauthorized alteration or repair followed.