SATCO NUVO 65-540 Series LED Tempered Glass Floodlights Instruction Manual

June 3, 2024
SATCO NUVO

LED TEMPERED GLASS
FLOODLIGHTS
Models: 65-541, 65-542, 65-543
Instruction Manual

INSTALLATION AND SAFETY INSTRUCTIONS

IMPORTANT: Read before installing fixture. Retain for future reference.

WARNING:

  • To avoid electric shock or component damage disconnect power before attempting installation or servicing.
  • To avoid electric shock or component damage, do not use the CCT switch and power range switch after installation.
  • This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
  • Use caution when handling this product during or after operation as it may become hot and cause burns. Disconnect product and allow cooling prior to servicing.
  • Any alteration or modification of this product is expressly forbidden as it may cause serious personal injury, death, property damage and/or product malfunction.
  • To prevent malfunction and/or electrical shock this product must be properly grounded.
  • Risk of fire, minimum 90°C supply conductors.
  • All connections should be capped with UL approved wire connectors.

Model #| Wattage Selectable| CCT Selectable| Voltage| Lumens| CRI| Operating Temperature
---|---|---|---|---|---|---
65-541| 15W/25W/35W| 3000K/4000K/5000K| 120-347V| 1800-4900| 80| —30° to 45°C (-22°F to 113°F)
65-542| 45W/60W/80W| 5400-11120
65-543| 100W/125W/150W| 12000-21000

INSTALLATION

Prior to installation, connect wires as shown in wiring diagram.
KNUCKLE MOUNTING
(Mounting plate included. Suitable for 15W/25W/35W and 45W/60W/80W models.)
STEP 1: Secure the fixture using the 1/2″ male thread to a 1/2″ female thread in junction box (or with provided mounting plate) or landscape post as shown in Figures 1 and 2).
STEP 2: The knuckle arm allows 180° rotation as shown in Figure 2.

SATCO NUVO 65-540 Series LED Tempered Glass Floodlights -
1

YOKE MOUNTING

(Suitable for all models.)
STEP 1: Remove existing mounting provided with the fixture by removing the securing bolts at the bottom of the fixture housing. Attach the yoke mount to the pre-tapped holes on the side of the fixture housing using the provided hardware.
STEP 2: Secure the fixture to wall or floor as shown in Figure 3, using appropriate anchors (not provided).
STEP 3: The yoke arm allows 90° rotation as shown in Figure 2.

SATCO NUVO 65-540 Series LED Tempered Glass Floodlights -
2

See page 2 for additional bracket installation options.
INSTALLATION (continued): Prior to installation, connect wires as shown in wiring diagram.
TRUNION MOUNTING (Suitable for all models.) STEP 1: Remove existing mounting provided with the fixture by removing the securing bolts at the bottom of the fixture housing. Attach Trunnion mount to the fixture reusing the securing bolts.
STEP 2: Secure the fixture to wall as shown in Figure 4, using the appropriate anchors (not included).
STEP 3: Loosen the pivot bolts and angle locking screw.
STEP 4: Adjust fixture to desired angle.
STEP 5: Tighten pivot bolts and angle locking screw.

SATCO NUVO 65-540 Series LED Tempered Glass Floodlights -
3

SLIPFITTER MOUNTING (Suitable for 60W, 80W, 100W, 150W.)
STEP 1: Place the slipfitter over the tenon and secure the fixture with the screws on the side of the slipfitter as shown in Figure 5.
STEP 2: Loosen the locking bolt and swivel fixture to desired angle as shown in Figure 6.
STEP 3: Tighten the locking bolt.
IMPORTANT: The installation height must be greater than 4 feet.

SATCO NUVO 65-540 Series LED Tempered Glass Floodlights -
4

Photocell, CCT and Wattage Adjustments

  • Use a screwdriver or coin to unscrew the protective plugs. See Figure 8 for all possible adjustments.
  • Photocell Adjustment: User may select “ON” to turn photocell on, or “OFF” to turn photocell off.
  • CCT Adjustment: User may select desired color temperature to 3000K, 4000K or 5000K.
  • Wattage Adjustment: User may select desired output wattage by sliding the switch to High, Medium or Low.
  • After adjustment is finished, screw the protective plug back and tighten it.

SATCO NUVO 65-540 Series LED Tempered Glass Floodlights -
5 Satco Products, Inc.
Brentwood, NY 11717

Documents / Resources

| SATCO NUVO 65-540 Series LED Tempered Glass Floodlights [pdf] Instruction Manual
65-541 65-542 65-543 LED Tempered Glass Floodlights, 65-541, 65-542, 65-543, 65-541 LED Tempered Glass Floodlights, 65-542 LED Tempered Glass Floodlights, 65-543 LED Tempered Glass Floodlights, 65-540 Series LED Tempered Glass Floodlights, 65-540 Series, LED Tempered Glass Floodlights, LED Glass Floodlights, Tempered Glass Floodlights, Glass Floodlights, LED Floodlights, Floodlights
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

SATCO NUVO User Manuals

Related Manuals