OUTDOOR INDUSTRIES LED-TCH-DIM Touch Panel Dimmer Instruction Manual
- June 8, 2024
- OUTDOOR INDUSTRIES
Table of Contents
OUTDOOR INDUSTRIES LED-TCH-DIM Touch Panel Dimme r
SUMMARIZATION
The LED-TCH-DIM touch panel dimmer is our new high-end controller. The glass panel design is beautiful as well as stylish. This dimmer boasts a high capacity touch control chip which increases the touch sensitivity and reduces accidental inputs. Used to control LED lamps and lanterns.
TECHNICAL PARAMETERS
- Working Temperature: -20-60°C
- Supply Voltage: DC12~24
- Output: 1 channel
- Connecting Mode: Common anode
- External Dimension: L 86 x W 86 x H 37mm
- Packing Size: L 90 x W 90 x H 60mm
- Net Weight: 125g
- Gross Weight: 150g
- Static Power: < 1W
- Output Current: < 8A
- Output Power: 12V: < 96W | 24V: < 192W
External Dimension
Interface Specifications
Controller Instructions
Touch panel has two buttons and a pulley. The keys function as follows:
Any state that can be opened or closed the controller outputs
Brightness select key. Can choose different brightness, a total of seven
change modes.
Pulley touch buttons, promise brightness select key, as many as 128 touch
points.
The key has two functions:
- Pulley brightness select key, namely the control mode for M key mode (brightness), if must realize the pulley of brightness, can press this button.
- The pulley brightness switch button: from 64 can be static color (brightness) switch.
Mode Functions
| Mode No. | Dims |
|---|---|
| 1 | 10% |
| 2 | 20% |
| 3 | 30% |
| 4 | 40% |
| 5 | 50% |
| 6 | 60% |
| 7 | 70% |
| 8 | 80% |
| 9 | 90% |
| 10 | 100% |
Typical Application
Installation
-
Open the touch panel as shown. Use a screwdriver to gently pry the gaps. Take the panel as shown in figure: the flat cable taken down.
-
Open the lock connection seat, take the flat cable wiring in the typical application. Reference the above diagram.
-
Install the switch base as shown in the illustrations. The connected line will touch installed on the wall in the cassette controller. Screw in the screws to attach the dimmer to the wall.
-
Cover the touch panel according to step up good row line, lock flat cable lock, cover panel.
Notes:
- Connect the load wire first, followed by the power wire. TO ENSURE THAT A SHORT CIRCUIT CAN NOT OCCUR CONNECT THE WIRES BEFORE YOU TURN ON THE POWER.
- The power supply voltage range is DC 12~24. DO NOT EXCEED THE RECOMMENDED VOLTAGE RANGE AS THIS CAN BURNOUT THE CONTROLLER.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>