SATCO 62-1664 7 Inch and 10 Inch CCT Selectable LED Disk Lights Instruction Manual
- June 3, 2024
- SATCO
Table of Contents
SATCO 62-1664 7 Inch and 10 Inch CCT Selectable LED Disk Lights
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT : Read before installing fixture. Retain for future reference
WARNING : Risk of Fire or Electric Shock
- Disconnect power before installation or maintenance of the fixture.
- This product must be installed in accordance with applicable installation codes by a person familiar with mentioned above codes and hazards involved. These fixtures are designed to meet the latest NEC requirements and are listed in full compliance with UL 1598.
- Supply wires must be rated minimum 90ºC. If uncertain consult an electrician.
- The product is purposed for interior use only, suitable for wet locations.
- Protect the product against direct contact with water.
- Assemble the product only with the use of parts provided and the housing; improper assembly may result in device failing which could damage the product, personal property or cause injury.
- CAUTION : When handling the fixture, do not apply pressure to the LEDs.
- Hold the fixture by the base only
HARDWARE INCLUDED
WIRING DIAGRAM
INSTALLATION
NOTE: Shut OFF the power at the circuit breaker and remove existing fixture, including the mounting hardware. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
-
Twist lens cover counter-clockwise to remove from Disk Light.
-
Select color temperature using the switch. See Figure 1.
-
Secure Crossbar to the Junction Box using Junction Box Screws.
-
The side of the mounting plate marked “GND” must face out.
-
7″ only: Place the Disk Light over the Crossbar and secure with Junction Box Screws through canopy Keyholes. See Figure 2. Make sure Disk Light is flush to the ceiling.
10″ only: Place the Disk Light over the Crossbar and secure the Crossbar through the canopy Keyholes with Wing Nuts. See Figure 3. Make sure Disk Light is flush to the ceiling.
-
Replace the lens back onto the Disk Light by turning clockwise
ELECTRICAL CONNECTION
Connect the fixture input wires to Junction Box wires as shown in the Wiring
Diagram, making sure all wire connectors are secure.
If the Junction Box has a Ground Wire (Green or Bare Copper), connect the
fixture’s Ground Wire to it. After wires are connected,
tuck them carefully inside the Junction Box.
- Dimming: This product is compatible with most residential type dimmers available on the market. The dimming performance will depend on kind of dimmer and dimmer settings. Visit Satco.com for an up to date list of compatible dimmers.
- Cleaning : Clean with a soft or damp cloth, make sure the power is OFF. Do not clean with liquids or abrasives.
- 5-Year Limited Warranty: The purchased product is covered with a 5-year warranty in respect of any defect in material or workmanship after purchase date. Satco shall bear no responsibility on account of guarantee, as well as shall bear no liability for any faults, in case of improper operation, use negligence, accident or exposure to natural hazard, or excessive use over the limits specified for the unit, or if any unauthorized alteration or repair followed.
© Copyright 2022 Satco Products, Inc. 7/22 v1.1