Westinghouse WC27GX6230 27 Inch Curved Gaming Monitor User Guide
- September 23, 2024
- Westinghouse
Table of Contents
Westinghouse WC27GX6230 27 Inch Curved Gaming Monitor
Product Information
Specifications
- Model: WC27GX6230 | WC32RX6230
- Included Items: DP Cable, Base/Stand, Power Cord, Adapter, Screws
- Trademark: HDMI
Product Usage Instructions
Connecting to Your PC:
Connect the monitor to your PC using the provided DP Cable.
Installation of Base
Base Installation Steps
- Remove the upper foam cover and place it aside.
- Take out the monitor film bag and place the monitor in the lower foam cover.
- Insert the base into the support and lock the 2 M4*16 screws.
- Tilt the base in the direction of the arrow into the back of the shell holes.
- Rotate the whole base clockwise downward and install it.
- To disassemble the base:
- Push up the slider near the VESA cover of the base.
- Rotate the entire base counterclockwise upwards.
- Tilt the base in the direction of the arrow and take it out.
- To stand the monitor upright, simply hold the stand with your hand. Note: Do not press the liquid crystal screen with your hand to avoid damage.
Frequently Asked Questions (FAQ)
Q: What should I do if I encounter issues with the monitor setup?
A: If you encounter any problems during setup or usage, please contact our
customer support at 800-701-0680 or
visit westinghouse.com/support for
assistance.
Quick Start Guide
WC27GX6230 | WC32RX6230
For customer support, scan the QR code.
Tools you will need:
ASSEMBLY
What’s included
- A – DP Cable (27″/32″)
- B – Base/Stand (27″/32″)
- C – Power Cord (32″)
- D – Adapter (27″/32″)
- E – Screws (27″/32″)
Conecting to your PC.
The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo
are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
in the United States and other countries.
Questions? Call 800-701-0680 or visit
westinghouse.com/support
Installation of base
Remove the upper foam cover and put it aside, take out the monitor film bag and put the monitor in the lower foam cover.
Base installation steps
- Insert the base into the support and lock attached 2 M4*16 screws;
- Tilt the base in the direction of the arrow into the back of the shell holes rotate the whole base clockwise downward and install it.
When it is necessary to disassemble the whole base, do the following steps；
- Push up the slider near the VESA cover of the base;
- Rotate the entire base counterclockwise upwards;
- Tilt the base in the direction of the arrow and take it out.
Simply hold the stand with hand to stand the monitor upright.
Note: During standing of the whole monitor, do not press the liquid crystal screen with hand to avoid damage to the screen.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>