FORTIN RM 442 Remote User Guide
- June 3, 2024
- FORTIN
Table of Contents
FORTIN RM 442 Remote
Overview
REMOTE STARTING
When leaving the vehicle it Is recommended that the driver pre-set the climate controls in preparation for a later remote start. To remote start the vehicle :
STEP 1
To remote-start the vehicle press the START button for approximately 3 second
The remote Green Led flash and a ascending melod1e will sound to confirm.
STEP 2
Approximately 5 seconds later the engine will crank and run for the selected
runtime (15 minutes by def au It).
If the vehicle fails to start on the first attempt, the Remote-Starter will wait 3 seconds before it will attempt to start the vehicle again. The Remote- Starter will attempt to start the vehicle 2 times (default) before giving up. (See Failed Remote Start, on the complete user guide). RUNTIME : On gas engines the Remote-Starter can run the vehicle for either . ..15._(detail.1O, .. 3 .. or..7. m.inutes … On. diesel engines. either.3O. (default), .. 6, .. or).5 minutes ..
REMOTE STARTING FROM FACTORY KEY FOB
IF OPTION AVAILABLE. To remote start the vehicle with the factory key fob:
PRESS LOCK 3 TIMES (By default) or PRESS LOCK UNLOCK LOCK.
Remote-start the vehicle.
WHEN SERVICING THE VEHICULE
Valet Mode disables the remote starter and alarm. Whenever vehicle 1s being serviced, or repaired or the vehicle is parked indoors; it is mandatory that Valet Mode be enabled to prevent an accidental remote start.
FROM THE ANTENNA
STEP 1
Turn the vehicle 1gn1t1on to (ON/RUN) position. The vehicle does not need to be started.
STEP 2
Within 10 seconds press and release the button on the antenna 3 times.
FROM THE REMOTE
Press and release the FUNCTION button, and than press simultaneously the LOCK and UNLOCK.
VALET MODE ENABLED:
The LED is ON
VALET MODE DISABLED:
The LED is OFF
KEY TAKEOVER AFTER REMOTE STARTING
KEY TAKEOVER FOR STANDARD KEY VEHICLE
STEP 1
Do not press the foot brake (the engine will shut down).
STEP 2
Insert the key into the ignition and turn to
ON position.
STEP 3
Press the foot brake.
**KEY TAKEOVER FOR PUSH-TO-START VEHICLE***
STEP 1
**FORD/ HYUNDAI / INFINITI / KIA I /MAZDA/ NISSAN/ SUBARU***
STEP 2
Enter the vehicle with the SMART-KEY.
STEP 3
Do not press the foot brake.
STEP 4
Press and release the Push-to-Start button once.
STEP 5
Press the foot brake.
STEP 6
The vehicle can now be put into gear and driven.
If the Smart Key is not detected the vehicle will shut down.
UNLOCK the doors with either the OEM remote, the remote-starter remote or the proximity remote*.
ACURA/HONDA /LEXUS/ SCION TOYOTA
STEP 2
The module will shut down the vehicle as soon as the drivers door is opened.
AUDI/BMW/CHRYSLER/ GMC
STEP 2
Press the foot brake.
STEP 3
The vehicle can now be put in to gear and driven.
*The remote starter key takeover may vary by vehicle, ask your adviser or technician for details.
**REMOTE START DIAGNOSTICS***
**ALARM DIAGNOSTICS***
THANK YOU FOR PURCHASING THIS REMOTE-STARTER/ALARM SYSTEM. WE RECOMMEND THAT YOU DOWNLOAD AND THOROUGHLY REVIEW THE COMPLETE USER MANUAL FOR MORE INFORMATION ABOUT THE REMOTE STARTER / ALARM SYSTEM AT : evoremotestart.com/RM442
CAUTION &WARNING
IT IS THE RESPONSIBILITY OF THE REMOTE CAR STARTER OPERATOR TO:
- Ensure that the vehicle is parked in a safe and responsible manner.
- Ensure that the vehicle is not remotely started indoors (garage, underground parking).
- Ensure that the vehicle is not remotely started with a passenger inside.
- Ensure that the vehicle is not remotely started with a window or the roof open.
- Ensure that the gearshift lever is in the NEUTRAL position and the parking brake is engaged on manual transmission in order to avoid accidents upon remote starting.
- When leaving the vehicle, ensure that the gearshift lever is in the “PARK” position for automatic transmission in order to avoid accidents upon remote starting.
- Make sure that the vehicle cannot start in the “Drive” position.
- Ensure that the remote starter is disabled or put into valet mode before servicing.
When servicing the vehicle, download the complete user guide for more information.
RM442- 2W: 2-WAYS REMOTE: FCCID 2ACKU-RM442 / IC 12084A-RM442
ANT-FMH-2W : ANTENNA : FCC 10: 2ACKU-A2W01FM / IC: 12084A-A2W01FM
MADE IN CANADA/ DOC# 74151 /REV: A20201209 / © 2019 ALL RIGHTS RESERVED