KEESON MC232 Control Box Instructions
- June 6, 2024
- KEESON
Table of Contents
Product Function instruction
MC232
Version：1.1
Electrical configuration diagram
Function Picture
Process of test
HEAD port
Connect to head actuator, control by a remote single:
Click head-up button on the remote, head actuator moves out, stop when
released；
Click head down button，head actuator moves in, stop when released；
This function takes effect only by pressing the corresponding button on the
remote.
FOOT port
Connect to foot actuator, control by a remote single:
Click foot up button， foot actuator moves out， stop when released；
Click foot down button， foot actuator moves in， stop when released；
This function takes effect only by pressing the corresponding button on the
remote.
Massage
Connect to head massage, control by remote:
Click head massage + button, head massage strengthens by one level;
Click head massage – button, head massage weaken by one level;
This function takes effect only by pressing the corresponding button on the
remote.
MULTIFUNCTION port
Connect with the same other Control box or Other accessories;
Power LED & PAIRING LED
Power supply for control box, PAIRING LED of control box flashes for 4 times,and then turns off, POWER LED turns on。
Power
Connect to the 29V DC;
Pair Function
Power up control box, pairing LED will be flash, the control box enters into
the mode of code paring, Press and holds the pairing LED of Remote, the
backlight of paring LED flashes, the backlight of remote flashes, the remote
enters into the mode of code paring; The backlight of paring LED of remote
stops flashing, and the paring led of control box stop flash, it indicates
that
the code paring is successful;
If fails, repeat all the processes above;
FLAT function
Press and release the FLAT button on the remote, the head and foot actuators
moves to a lower position(when the actuator is free, can turn off the
vibration motor and turn off the indicator light when press once ), stop when
pressing any button；
This function takes effect only by pressing the corresponding button on the
remote.
ZERO-G position function
Press and release ZERO-G button on remote, the head and foot actuator moves to
preset memory position, stop when pressing any button；
This function takes effect only by pressing the corresponding button on the
remote.
FCC Warning：
Please take attention that changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
ISED RSS Warning:
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of
the device.