FORTIN EVO-ALL Digital Remote Start System Instruction Manual

FORTIN EVO-ALL Digital Remote Start System

NOTES
THIS MODULE MUST BE INSTALLED BY A QUALIFIED TECHNICIAN. A WRONG CONNECTION CAN CAUSE PERMANENT DAMAGE TO THE VEHICLE.

DESCRIPTION

• Under steering column, START-STOP unit.
• Under steering column, START-STOP unit.
• Inside the Parking Light switch
  

ATTENTION
Before disconnecting a module, a computer or a control unit from a vehicle: Always disconnect the negative terminal from the vehicle’s battery.
In these vehicles, the factory keyless entry module is sensitive to interference and may cease to operate if some precautions are not taken. Disconnect the (-) terminal of the battery prior to disconnecting the connectors at the smart key module below the steering wheel to avoid damage to the smart key entry module.

1. Disconnect the (-) terminal of the battery.

2. Under the Steering Column
3. Under the Steering Column
4. Left of Steering Column
5. Right of Steering Column
6. Gently pull up the cover of the steering column.

Make the following connections.

AUTOMATIC TRANSMISSION WIRING CONNECTION

MANUAL TRANSMISSION WIRING CONNECTION

• Reconnect the (-) terminal of the battery.

DCRYPTOR PROGRAMMING PROCEDURE

Parts required (not included)

• 1x FLASH LINK UPDATER, 1x FLASH LINK MANAGER
• SOFTWARE | PROGRAMME
• Microsoft Windows Computer with Internet connection Ordinator Microsoft Windows avec connection Internet

1. Press and hold the programming button: Connect the 4-PIN Data-link harness (Black connector).

2. The Blue, Red, Yellow and Blue & Red LEDs will alternatively illuminate.

3. Release the programming button when the Blue LED is ON.

4. If the LED are not solid BLUE disconnect the 4-PIN Data-link harness (Black connector) and go back to step1.

5. Connect the required remaining harnesses.

6. Do not press the brake pedal. Press the Push-to-Start button twice to turn ON the ignition.

7. The Blue, Red and Yellow LEDs will alternatively illuminate.

8. The BLUE LED will flash rapidly.

9. Press the Push-to-Start button once to turn off the ignition.

10. The BLUE LED turn off.

11. The RED and YELLOW LEDs will alternated.

12. Disconnect all the connectors and after the Data-Link (4-pins) connector.

13. Microsoft Windows
    Computer with
    Internet connection*

14. AFTER DCRYPTOR PROGRAMMING COMPLETED
    Go back to the vehicle and reconnect the 4-Pin (Data-Link) connector and after, all the remaining connector.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>