FORTIN LC 500 Remote Starters And Alarm Systems Installation Guide

: June 5, 2024
: FORTIN

Table of Contents

FORTIN LC 500 Remote Starters And Alarm Systems
REGULAR INSTALLATION
WIRING CONNECTION
DCRYPTOR PROGRAMMING PROCEDURE
KEY BYPASS PROGRAMMING PROCEDURE 2/2
REMOTE STARTER FUNCTIONALITY
Read User Manual Online (PDF format)
Download This Manual (PDF format)

FORTIN LC 500 Remote Starters And Alarm Systems

REGULAR INSTALLATION

ADDENDUM – SUGGESTED WIRING CONFIGURATION

NOTES

The vehicles OEM remote and SmartKey are still operable during remote start.
NO KEY TAKEOVER

MANDATORY INSTALL

HOOD PIN

HOOD STATUS : THE HOOD PIN SWITCH MUST BE INSTALLED IF THE VEHICLE CAN BE REMOTE-STARTED WITH THE HOOD OPEN, SET FUNCTION A11 TO OFF.

Notice: the installation of safety elements are mandatory. The hood pin is an essential security element and must be installed.

THIS MODULE MUST BE INSTALLED BY A QUALIFIED TECHNICIAN. A WRONG CONNECTION CAN CAUSE PERMANENT DAMAGE TO THE VEHICLE.

WIRING CONNECTION

DCRYPTOR PROGRAMMING PROCEDURE

Press and hold the programming button: Connect the 4-PIN Data-link connector.
- The BLUE, RED, YELLOW and BLUE & RED LEDs will alternatively illuminate.
Release the programming button when the LED is BLUE.
- If the LED is not solid BLUE disconnect the 4-Pin connector (Data-Link) and go back to step 1.
Insert the required remaining connectors.
Do not press the brake pedal. Press the Push-to-Start button twice to turn on the ignition.
- Wait for the BLUE LED to flash rapidly and constantly.
Press the Push-to-Start button once to turn off the ignition.
- The BLUE LED will turn off

KEY BYPASS PROGRAMMING PROCEDURE 2/2

REMOTE STARTER FUNCTIONALITY

All doors must be closed.
Remote start the vehicle.

Unlock the doors with either:

The OEM remote
The remote-starter remote
Or the proximity remote
The module will shut down the vehicle as soon as the drivers’ door is opened.
Enter the vehicle with the Smart-Key.
Press the brake pedal.
Press the Push-to-Start button to start the vehicle.
The vehicle can now be put into gear and driven.

Notice: Updated Firmware and Installation Guides
Updated firmware and installation guides are posted on our website regularly. We recommend that you update this module to the latest firmware and download the latest installation guide(s) before the installation of this product.

WARNING
The information on this sheet is provided on an (as is) basis with no representation or warranty of accuracy whatsoever. It is the sole responsibility of the installer to check and verify any circuit before connecting to it. Only a computer-safe logic probe or digital multimeter should be used. FORTIN ELECTRONIC SYSTEMS assumes absolutely no liability or responsibility whatsoever on the accuracy or currency of the information supplied. The installation in every case is the sole responsibility of the installer performing the work and FORTIN ELECTRONIC SYSTEMS assumes no liability or responsibility whatsoever resulting from any type of installation, whether performed properly, improperly, or any other way. Neither the manufacturer nor distributor of this module is responsible of damages of any kind indirectly or directly caused by this module, except for the replacement of this module in case of manufacturing defects. This module must be installed by a qualified technician. The information supplied is a guide only. This instruction guide may change without notice. Visit www.fortinbypass.com to get the latest version.