SUPER BRIGHT LEDS LSFD-SW3C40W-H Selectable CCT Linear LED Strip Light User Manual
- June 3, 2024
- super bright leds
Table of Contents
SUPER BRIGHT LEDS LSFD-SW3C40W-H Selectable CCT Linear LED Strip Light
Wiring Diagram
Safety and Notes
The product should be installed in accordance with applicable national, state, and local building and electrical codes. To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures. Avoid looking directly into the lamp when illuminated. Ensure all mounts are securely attached and will support the weight of the fixture. Failure to properly support the fixture may result in damage or injury, for which the manufacturer does not assume responsibility.
Check product label for specific electrical specifications related to installation. Improper installation will void warranty.
CCT Selection
Use CCT selection switch to adjust CCT setting.
Installation Instructions (surface mount)
-
Measure and drill holes in mounting surface.
-
Remove diffuser lens using the releases pictured to the right.
-
Attach mounting plate. With supply power off, connect wiring.
Note: Conduit can be directly attached to mounting plate. -
Securely mount fixture.
-
Reinstall diffuser lens.
-
Select desired CCT value using switch.
Installation Instructions (optional hanging kit LSFD-HK)
- Measure and drill appropriate holes in ceiling and install hooks (not included) if needed.
- Attach cables to ceiling hooks or wrap around suitable pipe or beam.
- Attach triangular hangers to cables, then hang light on them.
- With supply power off, connect wiring.
- Adjust CCT using switch on the side of fixture.
4400 Earth City Expy, St. Louis, MO 63045
Tel no: 866-590-3533
superbrightleds.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>