SUPER BRIGHT LEDS HBUD2-50K100D-C2 LED High Bay Light User Manual

SUPER BRIGHT LEDS HBUD2-50K100D-C2 LED High Bay Light User Manual

Safety and Notes

• Product should be installed and serviced by a certified electrician in accordance with applicable national, state, and local building and electrical codes.
• To reduce the risk of electric shock, ensure that the main power source and  circuit breakers are switched off before performing any installation or wiring procedures.
• Avoid looking directly into lamp when illuminated.
• Ensure all mounts are securely attached and will support the weight of the fixture. Failure to properly support fixture may result in damage or injury, for which the manufacturer does not assume responsibility.

Wiring Diagram

³12 VDC AUX- on 300 W, 400 W, and 500 W models only

Eye Bolt/Hook Installation Instructions

1. Thread eye bolt / hook into hole on top of fixture and tighten.
   Hang fixture securely.

2. With supply power switched off, connect wiring.

Specifications

Environmental Specifications

Operating Temperature| -22°–122° F(-30°–50° C)
IP Rating| IP65

Check product label for specific electrical specifications related to installation.
Improper installation will void warranty.

Optional Accessories

100–300 W versions

• HBUD-MS (microwave motion sensor)
• HBUD-8 (polycarbonate reflector)
• HBUD-8-UB (U-bracket)

400–500 W versions

• HBUD-12-PR (polycarbonate reflector)

U-Bracket Installation Instructions

1. Secure mounting plates to fixture with provided screws.
2. Attach U-bracket to mounting plate with provided screws and nuts.
3. Attach mounting bracket to desired surface.
4. Position U-bracket at desired angle and secure in place.
5. With supply power off, connect wiring.

Polycarbonate Reflector Installation Instructions

1. Turn fixture upside down, if needed.
2. Line up the three holes on reflector with three threaded holes on the light.
3. Attach reflector using provided screws.

Motion Sensor Installation Instructions

1. Remove supply power prior to installation.
2. Position motion sensor and sensor junction box on opposite sides of the light and attach using provided hardware.
3.  Connect wiring according to wiring diagram below.

¹300 W, 400 W, and 500 W models only
²100 W, 150 W, 200 W, and 240 W models only

Rev Date: V1 01/20/2022
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>