super bright leds GSL-SW3B35-BK Gooseneck LED Sign Light User Manual
- May 15, 2024
- super bright leds
Table of Contents
super bright leds GSL-SW3B35-BK Gooseneck LED Sign Light
Product Information
Specifications
- Product Name: Gooseneck LED Sign Light
- Model: GSL-SW Series
- Environmental Specifications: IP65
Product Usage Instructions
Installation:
- Select desired CCT on the mount side of the light.
- Ensure the power supply is switched off before proceeding.
- Connect the mounting plate to the junction box.
- Place the gasket onto the mounting plate. Additional sealant can be used around the edge of the light if needed.
- Connect the wiring following the wiring diagram provided.
- Securely attach the light to the mounting plate.
- Loosen the set screws on the light head.
- Slide the reflector keyhole slots onto the screw heads.
- Tighten the screws once in place.
- Loosen the center adjustment screw at the knuckle and adjust the angle as needed.
Angle Adjustment:
To adjust the angle, loosen the locking nut and swivel the light to the
desired position. Note that the installed reflector may reduce rotation range.
Tighten the locking nut once you have achieved the desired position.
Safety and Notes
- Product should be installed and serviced in accordance with applicable national, state, and local building and electrical codes.
- To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures.
- Avoid looking directly into lamp when illuminated.
- Ensure all mounts are securely attached and will support the weight of the fixture. Failure to properly support fixture may result in damage or injury, for which the manufacturer does not assume responsibility.
- Suitable for wet locations and intended for outdoor use only.
- Suitable for wall mount only, minimum 4 ft from the ground surface.
Specifications
Environmental Specifications
- Operating Temperature: -40°–104° F (-40°–40° C)
- IP Rating: IP65
Check product label for specific electrical specifications related to installation. Improper installation will void warranty.
Wiring Diagram
Angle Adjustment
Loosen locking nut and swivel to adjust. Installed reflectors may reduce rotation range. Tighten when desired position is reached.
Important : Read all instructions prior to installation.
Installation
- Select desired CCT on mount side of light.
- With supply power off, connect mounting plate to junction box.
- Place gasket onto mounting plate. Additional sealant can be used around the edge of the light as needed.
- Connect wiring.
- Securely attach light to mounting plate.
- Loosen set screws on light head.
- Slide reflector keyhole slots onto screw heads.
- Tighten screws once in place.
- Loosen center adjustment screw at knuckle and adjust angle as needed.
- Rev Date: V1 03/30/2023 4400 Earth City Expy, St. Louis, MO 63045
FAQ
Q: What should I do if I encounter issues during installation?
A: If you encounter any difficulties during installation, please refer to
the user manual for troubleshooting steps. You can also contact customer
support for assistance.
Q: Can I use this product for indoor applications?
A: The Gooseneck LED Sign Light is designed for outdoor use with an IP65
rating. It is not recommended for indoor applications.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>