SUPER BRIGHT LEDS VTS2D-SW Series Vapor Tight Linear LED Light User Manual
- June 4, 2024
- super bright leds
Table of Contents
SUPER BRIGHT LEDS VTS2D-SW Series Vapor Tight Linear LED Light
Safety and Notes
- Product should be installed and serviced by a certified electrician in accordance with applicable national, state, and local building and electrical codes.
- To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures.
- Avoid looking directly into lamp when illuminated.
- Ensure all mounts are securely attached and will support the weight of the fixture. Failure to properly support fixture may result in damage or injury, for which the manufacturer does not assume responsibility.
Specifications
VTS2D-SW
IP Rating| IP65
Operating Temperature| -22°–113° F (-30°–45° C)
Check product labe specific electrical specifications related to installation. Improper installation warranty.
Wiring Diagram
CCT Selection
To select C pen the linear light by releasing the metal clips. This can be done prior to or during installation.
Installation
-
Measure and mount the provided mounting brackets.
-
Open the housing by unlatching the lens and setting it aside.
-
Connect wiring.
Note: If running in series, make certain to use the other watertight connector to run wiring out of the opposite end of the fixture. -
Reassemble fixture and press light into mounting brackets.
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>