NEC PE506UL LCD Projector User Guide
- June 3, 2024
- NEC
Table of Contents
PE506UL LCD Projector
User Guide
PE506UL LCD Projector
step1 Connect your computer to the projector.
step2 Connect the supplied power cord.
step3 Remove the lens cap.
**** (Only for PE506UL)
step4 Turn on the projector.
step5 Select a
source.
step6 Adjust an image size and position.
step7 Turn off the projector.
NOTE:
The color of the POWER indicator
Steady Blue
[Power On]| Steady Orange or
Blanking Orange
[Standby]
---|---
The color of the LIGHT indicator
Steady Green or
Blanking Green
[Power On]| Off
[Standby]
---|---
-
Connect your computer to the projector using the supplied computer cable (VGA).
-
Connect the supplied power cord.
-
Remove the lens cap. (Only for PE506UL)
-
Turn on the projector.
Press the (POWER) button on the projector cabinet or the POWER ON button on the remote control. -
Select a source.
TIP: Press the AUTO ADJ. button to optimize an RGB image automatically. -
Adjust an image size and position.
[Throw angle (Tilt foot)] 1. Place the projector perpendicular to the screen.
2. Rotate the left and right adjustable tilt foot to make adjustments to the desired height.
• Rotate the tilt clockwise to raise the projector, and counterclockwise to lower the projector or retract the adjustable foot.
• The tilt foot can be extended up to 0.71 inch/18 mm.
• There is approximately 3.5 degrees (up) of adjustment for the front of the projector.
[FOCUS]
Turn the focus ring.
[ZOOM]
Turn the zoom lever.
[Lens shift]
Turn the lens shift dial. -
Turn off the projector.
1. Press the (POWER) button on the projector cabinet or the STANDBY button on the remote control.
2. Press either the (POWER) or the STANDBY button again.
3. Mount the lens cap. (Only for PE506UL)
4. Disconnect all the cables.
© Sharp NEC Display Solutions, Ltd. 2021
Printed in China
Documents / Resources
| NEC
PE506UL LCD
Projector
[pdf] User Guide
PE506UL, PE506WL, PE506UL LCD Projector, PE506UL, LCD Projector, Projector
---|---