NGP-SLI-SC Soft Close for Sliding Aluminum Door Hardware Installation Guide
- July 27, 2024
- NGP
Table of Contents
SC
Soft Close for Sliding Aluminum Door Hardware
INSTALLATION INSTRUCTION
NGP-SLI-SC Soft Close for Sliding Aluminum Door Hardware
For the complete list of Aluminum Sliding Door Hardware, the most up-to-date product information and installation instructions, scan the QR code or visit ngp.com.
Designed for Doors 120 lbs. – 150 lbs.
Minimum Door Width When Using One Soft Close Device on a Single Door is 16″.
Minimum Door Width When Using Two Soft Close Devices for Soft Close Both
Directions on a Single Door is 31″.
-
If Track is already installed, disconnect Hangers f rom Door Plates and remove door. Remove both Hangers f rom track–Remove Door Plates from door.
-
Attach Door Plates 1 3/4″ (70mm) from door edge.
-
Engage Soft Close Dampener by pushing Dampener trigger toward (4) Wheel Roller.
This step is very important. DAMPENER MUST BE ENGAGED or soft close will not work. Soft Close Dampener may be DAMAGED if installed incorrectly. Door will have to be removed and installation will have to begin again. -
Insert Soft Close into track–4 Wheel Ball Bearing Hanger goes into Track first.
-
Hang Door
-
Slide door away from end of track (check to make sure all track screws are flat against track and does not interfere with movement of dampener hanger) and install Actuator Arm into track, with back of Actuator Arm 2 1/4″ or desired position from Jamb. HAND TIGHTEN (do not use power drill) Actuator Arm on track. Check to make sure Arm stayed straight in track. Slowly close door, checking to make sure door touches Jamb, if not. Slide door away from Jamb and readjust Actuator Arm. Slowly close door again, checking to make sure soft close is working properly. Once confirmed, begin using door normally.
NGP-SLI-SC-PRI-0522-A NGP MEMPHIS
4985 East Raines Road
Memphis, TN 38118
orders@ngp.com
NGP VEGAS
4584 Calimesa Street
Las Vegas, NV 89115
vegasorders@ngp.com
ngp.com
1-800-NGP-RUSH
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>