NGP SLSS1-6 Stainless Steel Sliding Door Hardware Installation Guide
- July 29, 2024
- NGP
Table of Contents
- NGP SLSS1-6 Stainless Steel Sliding Door Hardware Installation Guide
- 1. Prepare Hanger
- 2. Prepare Door for Hangers
- 3. Mount Hangers to Door
- 4. Attach Brackets
- 5. Secure Track
- 6. Fit Door Guide to Floor
- 7. Hang Door
- 8. Adjust Stops
- 9. Re-attach Anti-Rise Pins into Hangers
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
NGP SLSS1-6 Stainless Steel Sliding Door Hardware Installation Guide
SLSS1-6, SLSS1-8
Stainless Steel Sliding Door Hardware
For the complete list of Stainless Steel Sliding
Door Hardware, the most up-to-date product information and installation
instructions, scan the QR code or visit ngp.com.
WARNING: Must be installed into wall blocking.
If you have questions about what type of wall blocking is required, consult a
structural engineer.
1. Prepare Hanger
2. Prepare Door for Hangers
Drill four holes for two hangers.
3. Mount Hangers to Door
4. Attach Brackets
Locate centerline of track as shown on first page.
Using a level, mark a horizontal line twice the door width long. Mark bracket
screw locations, as shown on first page, into WALL BLOCKING. Attach wall
portion of brackets as shown.
Optional drywall spacers SLSS-DWS
If using drywall spacers: use 3/4″ drill bit to remove gypsum board at bracket
locations. Use appropriate thickness spacers to replace gypsum board removed
and seat against blocking.
5. Secure Track
Attach track to wall brackets as shown. Insert stops into track ends.
6. Fit Door Guide to Floor
7. Hang Door
Route bottom of door to receive floor mounted guide as shown. Lift door onto track. Make adjustments to hanger so that door is plumb.
8. Adjust Stops
9. Re-attach Anti-Rise Pins into Hangers
NGP MEMPHIS
4985 East Raines Road
Memphis, TN 38118
orders@ngp.com
NGP VEGAS
4584 Calimesa Street
Las Vegas, NV 89115
vegasorders@ngp.com
ngp.com
1-800-NGP-RUSH
Read More About This Manual & Download PDF: