NGP SLAL-75-BP Aluminum Sliding Door Installation Guide
- July 26, 2024
- NGP
Table of Contents
NGP SLAL-75-BP Aluminum Sliding Door
Specifications
- SKU: SLAL-75-BP / SLAL-75-BPF
- Track Lengths: 48″, 60″, 72″, 96″
- Max Door Weight: 75 lbs. each
- Door Thickness: 3/4″ to 1″
Product Usage Instructions
- Prepare Opening
- Measure the opening height required based on the door height plus specific measurements provided in the manual.
- Install Track and Hangers
- Use the provided screws to install the track and hangers. Ensure they are positioned correctly as per the instructions.
- Hang Doors
- Hang the doors on the hangers, making sure they rest properly on the rear rail.
- Adjust and Finish
- Adjust the doors for proper overlap and ensure they slide smoothly. Attach the pulls for easy opening and closing.
FAQs
- Q: What is the maximum weight capacity of each door for this hardware?
- A: The hardware is designed for doors up to 75 lbs. each.
- Q: What is the recommended door thickness for installation?
- A: The recommended door thickness is between 3/4″ to 1″.
INSTALLATION INSTRUCTION
Track
- (2) Front Hangers
- (2) Back Hangers
- (2) Brass Pulls
- (2) Chrome Pulls
- (1) Bottom Guide
-
8 x 5/8″ PH SMS
-
8 x 1 3/8″ PH SMS
- Prepare Opening
- Opening Height Max = Door Height + 2 1/16″
- Opening Height Min = Door Height + 1 3/4″
- SLAL-75-BP
- SLAL-75-BPF
- Side Mount Selection Chart****
Door Thickness| 3/4″| 1″| 1 1/8″| 1 3/8″
---|---|---|---|---
Front Hanger| (B) Deep Offset| A| A| A
Back Hanger| (A) Thin Offset| B| B| B
Door Gap| 5/16″| 3/4″| 5/8″| 3/8″
- Install Track and Hangers
- Center track in opening and secure with (#8 x 1 3/8″) screws
- Secure hangers onto door with #8 x 5/8″ screws provided 1 1/4″ in from each door edge as shown
- Raise hangers to top adjustment as shown
- Hang Doors
- Mount the rear door first by tilting the door back and resting the carrier on the rear rail
- Repeat for the front door on the front rail
- Adjust and Finish
- Adjust carriers so the door is square with a frame
- Install a floor guide in the center of the opening, where doors overlap
- Drill 2 1/8″ diameter holes 3/8″ deep to mount door pulls
CONTACT
- NGP MEMPHIS
- 4985 East Raines Road
- Memphis, TN 38118
- orders@ngp.com.
- NGP VEGAS
- 4584 Calimesa Street
- Las Vegas, NV 89115
- vegasorders@ngp.com
- NGP-SLI-SLAL-75-BPF-PRI-0531-B
- ngp.com.
- 1-800-NGP-RUSH
- For the complete list of Aluminum Sliding Door Hardware, the most up-to-date product information, and installation instructions, scan the QR code or visit ngp.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>