ELECTRO DEPOT 94334 Series 433 MHz Wireless Control 4 Channel System User Manual

June 3, 2024
ELECTRO DEPOT

ELECTRO DEPOT 94334 Series 433 MHz Wireless Control 4 Channel System

DIP Switch setting 1 to 4 match TX to RX, Factory set 1234 ON
Setting for auto reset on power failure
Factory set : Transmitter 5,ON, 6 OFF, 7 ON and 8 OFF

Receiver 5 ON , 6 OFF, 7 OFF, 8 OFF
NOTE: Auto reset delay approximate 10 seconds

INSTALLATION

Install the antenna as high as possible, clear from obstructions or metal structures
The antenna requires a good ground connection. Maximum Coax cable length 10ft (3.3m)
NOTE: Transmitter and receiver antennas shall be mounted facing the same vertical position, (same pattern polarity) even when there is no line of sight.

TEST the system before the final installation
Never operate the transmitter or receiver without the antenna.

  • Separate the transmitter and receiver at least 6 feet (2 meter) apart
  1. Connect the transmitter and the receiver to a power source
    • The receiver and transmitter have a power and carrier status LED indicators
  2. Close INPUT IN1 with a wire jumper in the transmitter terminal to GND
    At the receiver controller the LED goes on, and the relay 1 energizes.
    Test with a meter the closing operation on the relay terminal of the receiver

Same test procedure for each channel
Relay Contact is SPST Rated 6Amp, maximum 240V Pilot Duty
Power drain for each unit Standby 90 mA, Energized 400 mA @ 12VDC.

NOTE: We included Two small 7” Test antennas
Please test the devices before the final installation.

WARNING: Radio control equipment in not to be used in life safety.
DISCLAIMER: Contact a licensed professional for your project.

Electrodepot.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

ELECTRO DEPOT User Manuals

Related Manuals