AViANCE 59603 Toilette By Prince Matchabelli Installation Guide
- July 3, 2024
- AVIANCE
Table of Contents
AViANCE 59603 Toilette By Prince Matchabelli
Product Specifications
- Model: HD59603
- Power Source: Electrical
- Material: Glass
- CColour White
- Dimensions: [Provide specific dimensions if available]
Product Usage Instructions
Assembling & Installation
-
Shut off the power at the circuit breaker box before starting
the installation. -
Remove the old fixture carefully.
-
Follow the installation instructions provided below.
Connecting the Wires
- Connect the electrical wires as follows:
- Black wire from the fixture to the black house (hot) wire.
- White wire from the fixture to the white (neutral) house wire.
- Secure all wire nuts properly and consider using electrical tape for added safety.
- If your outlet box has ground wires (green or bare copper), connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
- Tuck the wire connections neatly into the wall junction box.
- After completing the connections, restore power to the junction box and test the fixture to ensure proper functionality.
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the
installation instructions do apply to this product. HD59603
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE
- Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to lose any small parts necessary for installation.
- Disconnect power at the main electrical panel before installation.
- Attach the mounting plate to the junction box using two junction box screws as shown. The side of the mounting plate marked “GND” must face out. The junction box is not included.
- Guide fixture wires through the hole in centre of the mounting plate.
- Follow wiring instructions carefully (see fig.2).
- Attach the back plate of the lamp body onto the mounting plate, aligning the back plate holes with the screw hole of the mounting plate on sthe ide, then lock it securely with mounting screws.
- Install the light bulb(not included) by the fixture’s specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING! Raise the glass insert to the cover of the lamp holder, by turning it clockwise until tight.
- With silicone caulking compound, caulk completely around where the back of the cover meets with the wall surface to prevent water from seeping into the outlet box.
CONNECTING THE WIRES
Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has ground wire (green or bare copper) connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
FAQ
- What should I do if the fixture does not work after installation?
- If the fixture does not work after installation, first ensure that the power source is connected correctly and that all wire connections are secure. If the issue persists, contact customer service for further assistance.
- Can I install this fixture outdoors?
- This product is designed for indoor use only. Do not expose it to outdoor elements to ensure its longevity and proper functioning.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>