Chargers AB0332 Wireless Charger User Manual
- June 4, 2024
- Chargers
Table of Contents
Chargers AB0332 Wireless Charger
Product Overview
- Charging area
- Indicator Light
- TYPE-C
- Instruction sheet
- TYPE-C Charging Cable
Specifications
- Input: 5V 2A, 9V 1.67A
- Wireless Output: 5V 1A, 9V 1.1A
- Working distance: 6mm
- Working efficiency ≥63%
- Magnetic alignment is suitable for compatible devices only.
- Suitable for all mobile devices with Qi technology.
- Wireless charging up to 15w high-speeding charging for compatible devices.
Operation
- Connect the cable to a USB port or into a USB AC adapter.
- Put your Qi-compatible device on top of the wireless charger, ensuring that it is face up and centrally positioned.
- When the wireless charger is working correctly a white light on the USB connector will light up.
Note: If your phone has a protective case you may need to remove it for a successful connection when using the wireless charger.
WARNING WORDS
This device has been tested and found to comply with Part 18 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This device generates, uses, and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this device does cause harmful
interference to radio or television reception, which can be determined by
turning the device off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment
This device complies with Part 18 of the FCC rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
- The distance between user and products should be no less than 20cm
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>