AViANCE HD52130 3 Light Brushed Nickel Outdoor Installation Guide

AViANCE HD52130 3 Light Brushed Nickel Outdoor

Product Usage Instructions

Assembling the Fixture:

1. Shut off the power at the circuit breaker and remove the old fixture.
2. Unpack the new fixture and lay out all parts carefully to avoid losing any small pieces.
3. Attach the mounting screw partway into the side hole of the crook crossbar, then secure it with a hex nut.
4. Attach the crossbar to the junction box using two box screws with the side marked GND facing out.
5. Follow the wiring instructions carefully as shown in Fig.2.
6. Hook the lamp body’s loop using the end of the arm and align the end hole.

Connecting the Wires:

1. Connect the Black wire from the fixture to the black house (hot) wire.
2. Connect the White wire from the fixture to the white (neutral) house wire.
3. Ensure all wire nuts are secured and consider wrapping connections with electrical tape.
4. If your outlet box has ground wires, connect the fixture’s ground wire accordingly.
5. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Restore power to the junction box and test the fixture. Thank you for choosing AVIANCE!

FAQ:

Q: What should I do if I encounter difficulties during installation?
A: For assistance with parts or assembly, please email customer service at: info@aviancelighting.net.

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.

WARNING!
SHUT THE POWER OFF AT THE FUSE OR CIRCUIT BREAKER.

ASSEMBLING THE FIXTURE

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker and remove the old fixture, including the single bar. Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to lose any small parts necessary for installation.
2. Attach the mounting screw part way into the side hole of the crook crossbar, then lock it securely with a hex nut until becoming. Attach the crossbar to the junction box using two box screws. The side of the crossbar marked “GND” must face out.
3. Follow wiring instructions carefully (see fig.2).
4. Using the end of arm(A) hook the lamp body’s loop, align the end hole of the arm(A) with the top hole of the back plate, and lock it securely with screw(E) and hex nut.
5. Attach the back plate of the lamp body(B) onto the junction box, aligning screws on a crossbar with mounting holes and locking it securely with the ball nuts(C).
6. Install the light bulbs(Not included) according to the fixture’s specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
7. With silicone caulking compound, caulk completely around where the back of the cover meets with the wall surface to prevent water from seeping into the junction box.

CONNECTING THE WIRES

CONNECTING THE WIRES (Fig.2)

1. Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has ground wires (green or bare copper) connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
2. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction box and test the fixture.

Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service at: info@aviancelighting.net.

©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING, INC.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>