AViANCE HD09141 Light Black Cast Brass Hardwired Outdoor Installation Guide
- July 3, 2024
- AVIANCE
Table of Contents
AViANCE HD09141 Light Black Cast Brass Hardwired Outdoor
Product Specifications
- Model: HD09141
- Fixture Type: Ceiling Light Fixture
- Power Source: Electrical
- Maximum Wattage: Refer to fixture specifications
Assembling the Fixture
- Shut off the power at the circuit breaker box and remove the old fixture and hardware from the Junction Box.
- Unpack the new fixture and lay out all parts in a clear area, ensuring not to lose any small parts required for installation.
- Install a compatible light bulb (not included) according to the fixture’s specifications. Do not exceed the maximum wattage rating.
- Attach the lamp holder (B) to the fixture body (A) by aligning the side hole with the screw hole of the lamp holder. Secure it with the knob screw (C).
- Attach the assembly fixture body onto the post (E, not included) and secure it with the screw (D).
Connecting the Wires
Refer to Fig.2 for wire connections
- Connect the Black wire from the fixture to the black house (hot) wire.
- Connect the White wire from the fixture to the white (neutral) house wire. Ensure all wire nuts are secured.
- If your outlet box has ground wires, connect the fixture’s ground wire accordingly. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
- Tuck the wire connections neatly into the post.
FAQ
Q: What should I do if I exceed the maximum wattage rating?
A: Exceeding the maximum wattage rating can be dangerous and may damage the
fixture. Ensure to always use bulbs within the specified wattage range.
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the
installation instructions do apply to this product.
HD09141
- WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
- ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE
- Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
- Install the light bulb (Not included) in accordance with the fixture’s specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
- Attach the lamp holder (B) insert the fixture body (A), aligning the side hole with the screw hole of the lamp holder (B), then lock it securely with the knob screw (C).
- Attach the assembly fixture body onto the post (E, Not included) and lock it securely with the screw (D).
CONNECTING THE WIRES
- Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has a ground wires (green or bare copper) connect fixture’s ground wire to it. Otherwise attach the bare copper fixture wire to the green ground screw on the mounting plate.
- Tuck the wire connections neatly into the post..
Your installation is now complete. Return power to the junction box and test the fixture.
Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service at:
info@aviancelighting.net
©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING,INC.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>