kogan NBKMETLDETA Kids Metal Detector with LCD Display User Guide

July 3, 2024
Kogan

kogan NBKMETLDETA Kids Metal Detector with LCD Display User Guide

kogan NBKMETLDETA Kids Metal Detector with LCD Display - front
page

OVERVIEW

kogan NBKMETLDETA Kids Metal Detector with LCD Display - product
OVERVIEW

INSTALLATION

Note :
The metal detector comes ready to use. The only adjustments required are the length of the stem and the angle of the search coil.

Adjusting the Stem

  1. Turn the stem’s locknut clockwise until it loosens.
  2. Adjust the length of the stem so that you can walk comfortably with the search coil at an optimal distance of around 1- 5cm above the ground.
  3. Retighten the stem’s lock nut counterclockwise to lock it in place.

Adjusting the Search Coilkogan NBKMETLDETA Kids Metal Detector with LCD
Display - Adjusting the Search Coil  

  1. Loosen the knobs at the search coil and rotate the coil angle until it is parallel with the ground.
  2. Tighten the knobs just enough to keep the search coil from rotating or wobbling.

Installing the Battery

  1. Loosen the screw with a screwdriver, then remove the battery compartment cover.


  2. Identify the polarities of a 9-volt battery and the polarities marked inside the compartment. Insert the battery into the compartment in the same direction as indicated by the marks and replace the compartment cover.

OPERATION

  1. Open the LCD.
  2. Slide the ‘Power’ switch upwards to turn on the detector. The green LED illuminates, indicating that the detector is ready for operation. Meanwhile, the LCD displays . Slide the ‘Power’ switch down to turn off the detector.
  3. Hold the detector in a comfortable position with the search coil parallel to a flat surface where there is no metal object.
  4. Place a sample coin on the ground. Sweep the coil in a side-to-side motion to find the sample.
  5. During searching, the LCD displays When the detector finds a metallic object, the red LED illuminates, a beep sound will be heard, and the LCD displays .
  6. When the LCD displays replace the battery.

Hints for Searching

  • The detector uses motion detection. To find metal targets, you must either move the coil or move the metal sample above the coil.
  • Sweep the search coil in a side-to-side motion.
  • Take your time. Walking too fast may cause you to miss a target. Never sweep the search coil as if it were a pendulum.

Rules to be Observed

  • Always obtain permission before searching any site.
  • Respect the rights and property of others.
  • Observe all national, state, and local laws while treasure hunting.
  • Never destroy historical or archaeological treasures. If you are unsure about an object you have found, contact a museum or historical society in your area.
  • Leave the land and vegetation as it was. Fill in any holes you dig.

CLEANING & CARE

  • The search coil pad is waterproof and can be submerged in either fresh or salt water. However, do not let water enter the handle. After using the search coil in salt water, rinse it with fresh water to prevent corrosion of the metal components.
  • Never attempt to recharge the non-rechargeable battery.
  • Remove the exhausted battery to avoid leaking.
  • Handle the detector gently and carefully. Dropping it can damage the circuit board and cases and can cause the detector to work improperly.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals