hidealite 75 046 57 LED STRIP Instructions
- June 11, 2024
- hidealite
Table of Contents
75 046 57 LED STRIP
Instructions
75 046 57 LED STRIP
E-nr| Snro| El.nr| GTIN| Length| Max.Length| LED color| Cutting increments|
Cooling via aluminum profile is required| Output max/m| Voltage DC
---|---|---|---|---|---|---|---|---|---|---
75 046 57| 42 223 89| 32 359 63| 7.39E+12| 5m| 5m| 3000K| 50mm| Yes| 19,2W|
24V
75 046 58| 42 223 90| 32 359 64| 7.39E+12| rm| 5m| 3000K| 50mm| Yes| 19,2W|
24V
75 057 24| 41 435 03| 32 425 45| 7.39E+12| 5m| 5m| 4000K| 50mm| Yes| 19,2W|
24V
75 057 25| 41 435 04| 32 425 46| 7.39E+12| rm| 5m| 4000K| 50mm| Yes| 19,2W|
24V
SAFETY INSTRUCTIONS
Read these instructions carefully before commencing installation and retain for future reference. The luminaire should be installed by a licensed electrician and in accordance with local regulations. Make sure that the power is off before installation or maintenance.
Installation & Safety Instructions
- The installation should be performed by a qualified electrician.
- See the table of technical specifications and follow the instructions to perform the installation in a safe and correct manner; note the recommendations for maximum lengths.
- Make sure that the LEDstrip’s voltage corresponds with that of the drive unit and ensure that the polarity is correct.
- When two or more LEDstrips are interconnected, make sure the maximum recommended length is not exceeded.
- Make sure the power is switched off during installation and that the LEDstrips do not overlap to avoid overheating.
- It is important that the LED luminaire’s maximum specified ambient temperature is taken into consideration in order to guarantee its life span, if this is exceeded, the life span can be shortened drastically.
- Use the recommended/approved assembly fittings to ensure the lifespan of the LEDstrip.
- The LEDstrip must not be switched on when rolled up.
- LEDs are sensitive components and must be treated with care and not subjected to mechanical stress.
- The flexible LEDstrip must not be bent more than the recommended bending radius.
- The LED chip should not be exposed to direct sunlight when switched on.
- The double-sided adhesive tape is for installing the lights, but may need to be complemented with heat-resistant silicone. When installed in the profiles (not uplight) recommends heat-resistant silicone for a permanent and sustainable installation. Do not apply silicone directly on the LED chip but along the sides.
Installation
Installation – Quick Joint 8mm IP20
Installation – Quick connection 8mm IP20
Elektro Elco AB, Tallvägen 5, SE-56435 Bankeryd, Sweden
[email protected]
www.hidealite.se
www.hidealite.uk
www.hidealite.fi
www.hidealite.no
www.hidealit
References
- Vi udvikler og sælger LED belysning - Hidealite
- LED-valaisimet & LED-valaistus kotiin ja julkisiin tiloihin - Hide-a-lite
- LED-belysning, downlights, spotlights och utendørs belysning av topp kvalitet - Hidealite
- Hide-a-lite - LED-belysning & LED-armaturer för ditt projekt! - Hide-a-lite
- LED lighting of the highest quality - Hidealite