EATON Smart Breaker to Wi-Fi Instructions
- June 6, 2024
- EATON
Table of Contents
Smart Breaker to Wi-Fi
Instructions
Step 1
Install Smart Circuit Breaker
Ensure that the smart circuit breaker is installed into the load center and
powered up.
Refer to the instructions in the box or the installation video.
Always use a qualified electrician to install and wire the smart circuit
breaker.
Step 2A
Create an Account
Download the EM Install app on the Apple App Store and Google Play Store.
Create an account and verify it with an active email address.
Log in at the home page.
Step 2B
Enter Network Information
| 
| 
---|---|---
Touch the “CONFIGURE A DEVICE”
button and select “Basic” setup.| Note: “Basic” setup is recommended.
Configuration through the “Advanced” setup is not covered.| The app will
automatically select the Organization you have been invited to.
Note: If you have been invited by other organizations, their names will
appear in this
list. If you have not been invited to any Organizations, select the “Continue
with Training Mode” button and select “Use Test Organization”.
| 
---|---
Add the address and load center location where the smart breaker is installed
and touch “NEXT”| Enter the name and password for the Wi-Fi network you would
like to connect the smart circuit breaker to.
Note: For future smart breaker setups, the Wi-Fi network info will be
saved and accessible in the drop-down menu for the Network Name.
Installer Quick Start Guide – EM Install App Effective December 2021
Step 3
Enable BlinkUp
On the Smart Breaker, press the “DISPLAY” button and ensure that the Network Status LED is blinking. If it is, then touch the “NEXT” button on your phone.
Step 4
BlinkUp
|
|
---|---|---
After reading the instructions on the phone, touch the “START BLINKUP”
button.| After reading the Warning message, touch “I UNDERSTAND”, then place
your phone’s screen AGAINST the Network Status LED on the smart breaker until
your phone vibrates and beeps.| Note: Do NOT look at the screen during
BlinkUp. This should take no more than 90
seconds. If your device is already blinking orange, it failed to connect.
Touch the “CANCEL” button to try to connect again.
|
---|---
Once the BlinkUp process completes, you will see the smart breaker’s progress
on your phone and will be notified once the device is successfully connected
to the Wi-Fi network.| The device is connected.
Eaton
1000 Eaton Boulevard
Cleveland, OH 44122
United States
Eaton.com| © 2021 Eaton All Rights Reserved
Printed in the USA
Publication No. PA003026EN
December 2021| Eaton is a registered trademark.
All other trademarks are property
of their respective owners.
---|---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>