JetScrub Pet How to clean brush roll and nozzle | Support

• Unplug machine

  • Remove nozzle by pulling upward on both sides

    • Check for cracks or damage on nozzle
    • If cracked or damaged, a replacement nozzle should be ordered

  • Remove brush by grabbing brush roll tab and pulling up

    • Inspect for damage
    • If damaged, a replacement brush roll should be ordered

  • Clean out nozzle with nozzle clean out tool

  • Rinse both brush roll and nozzle with warm water

  • Remove hair wrap and debris around brush roll and brush roll ends

  • Test brush by holding the pull tab and spinning other end

    • If brush doesn’t spin, a replacement brush needs to be ordered

  • Check plastic drive gear, (where brush roll is inserted into, on foot of machine) remove debris wrapped in this area

    • Turn gear by hand to make sure it spins
    • If gear doesn’t turn by hand or is deformed, Contact Us

  • Once dry, insert brush roll and reattach nozzle

    • To insert brush roll put right side of brush into foot first, then push down side with brush roll tab until it is secured into place

  • Clear any debris and check for damage in suction gasket

  • For nozzle, line up tabs on front edges of foot and push nozzle into place until it clicks

  • Recipient Email

Your Email

Your Name

Was this answer helpful?

Yes
No

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>