Tranya T10 Pro Wireless Bluetooth Earbuds User Manual
- June 6, 2024
- Tranya
Table of Contents
Tranya T10 Pro Wireless Bluetooth Earbuds
PACKAGE LIST
- Wireless Earbud • 2 Magnetic Charging Case• 1
- User Manual• 1
- Ear Tips• 3 [5/M/L)
- Type-C Charging Cable* 1
IMPORTANT NOTES
- Register your product on tranya.com to get an EXTRA three-month warranty for free.
- Before using the Tl O Pro wireless earbuds, please charge both the case and earbuds.
- We provide three pairs of rubber ear tips [including the set installed on the earbuds, please choose the best fit for you.
- If both earbuds don’t sync together, please reset the earbuds.
- If the earbuds don’t charge, please clean the charging slot on the case and the contact surface on the earbuds.
- If the sound becomes low without control, please use tweezers to take out/remove the net inside the earbuds.
TOUCH CONTROL
SWITCH SOUND EFFECTS
Two different sound effects on the T10 Pro: Normal Mode and Bass Boosted Mode. The Normal Mode is for those who prefer a sound with bright vocals and crisp treble. The Bass Boosted Mode is for those who prefer a warm, heavy bass.
POWER ON
(Long press and hold BOTH earbuds for 4 seconds)
POWER OFF
[Long press and hold EACH earbud for 4 seconds] Note: When the charging case is at a low battery or out of power, the earbuds will not automatically power on/off, please turn them on/off manually.
WEARING
- Step 1: Put the earbuds into your ears.
- Step 2: Rotate the earbuds to the auricle side to fit snugly.
CONNECT THE EARBUDS
- Step 1: Power on the earbuds and turn on the Bluetooth in your phone.
- Step 2: Select “Tranya T1 O Pro· and confirm.
CHARGING
- Charging the Earbuds
- Charging the Case
- Charge it with the included Type-C cable.
- Charge it with a wireless charging pad[Not included).
HOW TO RESET THE EARBUDS
If your earbuds stop syncing with each other, please follow the below steps to reset the earbuds:
- Remove the two earbuds from the charging case, then turn them off.
- Make sure the earbuds are off, then keep your fingers in the touch area for up to 8 seconds, until the red LEDs start flashing.
- The earbuds will sync together and enter the pairing mode automatically.
FAQ
- Q: Why does signal interruption occur in some places, such as along the railway and the airport?
- A: There are usually lots of underground cable lines along the places mentioned above, which might cause electromagnetic interference and result in signal interruption.
- Q: My earbuds don’t charge, what can I do?
- A: Please try to follow the below steps:
- Clean the charging slot on the charging case.
- Clean the charging connector on earbuds.
- Q: Why my earbuds don’t power on/off] automatically?
- A: The earbuds would not power off automatically when the case is at a low battery or out of power. Please recharge the case. And you can long pness for four seconds to power on and long press for four seconds to power off the earbuds.
- Q: Will the Bluetooth mouse cause signal interference?
- A: Perhaps. When your Bluetooth mouse and earbuds are connected to the same device, it might happen.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>