JMTek WPC38810W Wireless Charger Instruction Manual
- June 3, 2024
- JMTek
Table of Contents
JMTek WPC38810W Wireless Charger
Please read the following carefully before using the device to ensure safe and proper Use.
Package Content
- Wireless Charger
- USB A to USB-C fast charging cable
- User Manual
Specifications
- Input: DC 5V,2A/ DC 9V,2A
- Output: 5W/10W
- Charging Distancesomm
General information
- This charger Works with all Ql-compatible devIces (please make sure yOur device is Qi-compatible)
- For normal operation, no weaker than DC 5V, a 2A adapter is required
- For fast wireless charging mode, use the QC 2.0/QC 3.0 or PD adapter and compatible smartphones.
- This wireless charger can charge smartphones with a non-metal protective case or silicone cOvers that are no thicker than 6mm.
Instructions
Connect the USB cable(included) to a power outlet rated at DC 5V/2A or 9V/2A, and the Type-C plug to the Type-C input of the wireless charger. Place your Qi-compatible phone with an inductive (wireless) charge feature onto the charger (back of the phone to charger), then wireless charging of the phone will start immediately.
Note
Only devices which support Qi wireless charge technology can be wirelessly
charged from this charger, please check your device specifications. Some phone
cases do not support Wireless Charging due to the thickness and design. If
your phone is compatible with Wireless Charging and you are unable to charge
it wirelessly, please remove your phone case and retry.
Caution:
Do not drop, disassemble or modify this product. Do not expose this product to
fire or excessive heat. Do not expose this product to water or excessive
humidity. Do not put any bare metal on the surtace area of the wireless
charger when it is operating.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>