Tranya F1 True Wireless Earbuds User Manual
- June 5, 2024
- Tranya
Table of Contents
Tranya F1 True Wireless Earbuds
PACKAGE LIST
IMPORTANT NOTES
- Register your product on tranya.com to get an EXTRA three-month warranty for free.
- Before using the F1 wireless earbuds, please charge both the case and earbuds.
- If both earbuds don’t sync together, please reset the earbuds.
- If the earbuds don’t charge. please clean the charging slot on the case and the contact surface on the earbuds.
- If the sound becomes low without control, please use tweezers to take out/remove the net inside the earbuds.
BUTTON CONTROL
POWER ON
POWER OFF
Note: When the charging case is at low battery or out of power, the earbuds
will not automatically power on/off, please turn them on/off manually
WARNING
- Put the earbuds into your ears.
- Rotate the earbuds to auricle side to fit snugly.
CONNECT THE EARBUDS
- Power on the earbuds and turn on the Bluetooth in your phone.
- Select “F1” and confirm.
CHARGING
-
POWER DISPLAY
-
Charging the Case
-
Charge it with a wireless charging pad(Not included).
-
Charge it with the included Type-C cable.
Charging Last number is flashing.
Fully charged: Number 100% is on. -
Charging the Earbuds
Charging: White indicator is on; Power display lights up for 10s.
Fully charged- White indicator is off.
HOW TO RESET THE EARBUDS
If your earbuds stop syncing with each other, please follow the below steps to reset the earbuds:
- Remove both earbuds from the charging case, then turn them off;
- Make sure the earbuds are off, then press both buttons and hold for 8 seconds, until the red LEDs start flashing:
- The earbuds will sync together and enter the pairing mode automatically
FAQ
-
Why does signal interruption occur in some places, such as along the railway and the airport?
A: There are usually lots of underground cable lines along the places mentioned above, which might cause electonmagnetic interference and result in the siganal interruption. -
My earbuds don’t charge, what canI do?
-
Why my earbuds don’t power on/off automatically?
A: The earbuds would not power off automatically when the case is at low battery or out of power Please recharge the case. And you can long press for four seconds to power on and long press for four seconds to power off the earbuds. -
Will the Bluetooth mouse cause the signal interference?
A: Perhaps. When your Bluetooth mouse and earbuds are connected to the same device, it might happen.
Manufacture:
Name: CHANDASUNG TECH ISHENZHENI CO.,LTD
Address: Rm 802,Building B, Zhonghengsheng High-tech Zone, No.3 Xinyu
Road Xinqiao Street, Bao’an District, Shenzhen, China,
FCC Stätement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may ause u nesire operation. authority to operate
the equipment. this unit not expressly approved by the party responsible for
compliance could void the users
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. ihis equipment generates, uses and
can radiate radio frequency energy ana, not installed na Use in accordance
with tne instructions, ay cause Samui interference to radio COmmunicauons.
However, tnere is no guarantee nat interference wil not occur n a particular
installation. f this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device and its antenna(s) must not be co-located or operation in
conjunction with any other antenna or transmitter.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement in
portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>