Tranya F4 True Wireless Earbuds User Manual
- June 4, 2024
- Tranya
Table of Contents
True Wireless Earbuds
User Manual
V20220624
F4
True Wireless Earbuds
User Manual.
SCAN QR CODE FOR EXTENDED WARRANTY
15-MONTH EXTENDED WARRANTY ACTIVATE WITHIN 14 DAYS tranya.com/pages/register-
product
Email: support@tranya.com
PACKAGE LIST
IMPORTANT NOTES
-
Register your product on tranya.com to get an EXTRA three-month warranty for free.
-
Before using the F4 wireless earbuds, please charge both the case and earbuds.
-
If both earbuds don’t sync together, please reset the earbuds.
-
If the earbuds don’t charge, please clean the charging slot on the case and the contact surface on the earbuds.
-
If the sound becomes low without control, please use tweezers to take out/remove the net inside the earbuds.
BUTTON CONTROL
| Play/Pause | Press one time(L/R) | |
|---|---|---|
| Previous/Next track | ||
| Volume down/up | Press 3 times(L/R) | |
| Activate Siri/other voice control software | Press twice(L/R) | |
| Answer/End a call | Press and hold for 1 second (L/R1 | |
| Reject a call | Press one time(L/R) | |
| Game Mode ( Automatically return to normal mode after power off | Press and |
hold for 1 second(L/R)
POWER ON
POWER OFF Note: When the charging case is at a low battery or out of power, the earbuds will not automatically power on/off, please turn them on/off manually. WEARING
-
Put the earbuds into your ears.
-
Rotate the earbuds to the auricle side to fit snugly.
CONNECT THE EARBUDS
-
Power on the earbuds and turn on the Bluetooth in your phone.
-
Select “F4” and confirm.
CHARGING
- Power display
HOW TO RESET THE EARBUDS
If your earbuds stop syncing with each other, please follow the below steps to reset the earbuds:
-
Remove both earbuds from the charging case, then turn them off;
-
Make sure the earbuds are off, then press both buttons and hold for 8 seconds, until the red LEDs start flashing;
-
The earbuds will sync together and enter the pairing mode automatically.
FQA
Q: Why does signal interruption occur in some places, such as along the
railway and the airport?
A: There are usually lots of underground cable lines along the places
mentioned above, which might cause electromagnetic interference and rea sult
in signal interruption.
Q: My earbuds don’t charge, what can I do?
A: Please try to follow the below steps:
-
Clean the charging slot connector on earbuds.
-
Clean the charging on the charging case.
Q: Why my earbuds don’t power on/off automatically?
A: The earbuds would not power off automatically when the case is at low
battery or out of power. Please recharge the case. And you can long press for
four seconds to power on and long press for four seconds to power off the
earbuds.
Q: Will the Bluetooth mouse cause signal interference?
A: Perhaps. When your Bluetooth mouse and earbuds are connected to the same
device, it might happen.
Manufacturer:
Name CHANDASUNO TECH SHENZHEN) CO., LTD
Address: Rm 802, Building B, Zhonghengsheng High-tech Zone, No.3 Xinyu
Road Xinqiao Street, Baoan District, Shenzhen, China.
For more information, please visit: tranya.com
For any assistance, email us: support@tranya.com
Skylimit Service GmbH Roedingsmarkt 20 20459 Hamburg
HUA TENG LIMITED 3 Glass Street, Hanley, Stoke On Trent, ST1 2ET United
Kingdom
Made in China
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device and its antenna(s) must not be co-located or operated in
conjunction with any other antenna or transmitter.
Radiation Exposure Statement The device has been evaluated to meet general RF
exposure requirements in portable exposure conditions without restriction.
Product Model: F4 PMN: True Wireless Earbuds
ISED statement English: This device contains license-exempt
transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic
Development Canada’s license-exempt RSS(s). Operation is subject to the
following two conditions: (1) This device may not cause interference. (2) This
device must accept any interference, including interference that may cause
undesired operation of the device.
This device meets the exemption from the routine evaluation limits in section
2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain
Canadian information on RF exposure and compliance.
This equipment complies with Canadian radiation exposure limits set forth for
an uncontrolled environment.
The device has been evaluated to meet general RF exposure requirements. This
equipment should be installed and operated with a minimum distance of 0mm
between the radiator & your body.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>