CryoFX Cryo Swing Jet CO2 Jet Machine User Manual

: June 5, 2024
: CryoFX

Table of Contents

CryoFX Cryo Swing Jet CO2 Jet Machine
SPECIFICATIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

CryoFX Cryo Swing Jet CO2 Jet Machine

SPECIFICATIONS

Weight:19.8 pounds / 9Kg
Pressure Rating: 0-1000 psi / 69Bar
Noise Level:110 decibels
Color:Black
Distance:20-30 feet
Range: 180 Degrees
Material: ABS/Brass/Steel
Voltage: 110VAC/220VAC 50/60Hz
Dimensions: 11.81″ x 7.09″ x 9.06″ Il 30cm x 18cm x 23cm
Operation: DMX 512 Standard DMX Controller
Hardware: 2250 psi Hose with attached CO, tank oonnector fiting.
Description: This Cryo Swing Jet allows you to cover 180° degrees of back

Unpack CryoFX Swing Cryo Jet, hose, and cable. Locate fitting on both hose and Swing Cryo Jet as pictured Delow. Pul back the OutSIde part ng) ot the Titting on the hose and insert the titing on the swing yo Jet as shown below. Let 9o of rning as you push both fittings together until the outer ring snaps back forward. This wll lock the hose and Cyo Jet together. Gentiy pull both fitings apart to make sure the hose is attached to the Swing Cryo Jet.
Locate the panel show below in the first image. Locate the end of the DMX cable shown below. Plug the end of the DMX cable, as shown below, into the unit and the other end into your DMX controller. Set the DMA to your preterred channel using tne smal Duttons above and Delow to change the numberS. For stan dard use, leave DMx set to 001 and this Will allow you to use the swing Cryo Jet on channel 1. Note that 2 taders are used with DMX control: 1 for on/off of Jet and 1 for sWina arm control.
Locate end of hose with the fitting shown below. Take the piece of tape off the top of the fitting and throw it away. Make sure the plastic O-ring stayes inside the fitting. Screw fitting onto tank with your hand until it’s tight. Then take an adjustable wrench, as shown below, and tighten the fitting onto the tank fairly tight. Do not tighten too tight as damage or breakage may result.
SLOWLY turn the valve on top of the tank. The hose may move as the liquid CO2 enters the hose and makes it stif. Check for any leaks you may see as you open the valve more. If you notice leaks, turn off the valve and locate leaks. Once located contact CryoFX. When finished using, turn valve on top of tank in opposite direction as the last time you turned it so as to close the valve. Activate Cryo Jet a few more times to let the remaining CO2 in the hose out.

WARNING: Co2 Blasts cannot exceed 3 seconds in length for each blast. Two blasts cannot Occur within 5 seconds of each other. Power must be connected last as to ensure safety.

Is there a warranty on this Cryo Jet?
Yes, there is 1 year limited warranty which will cover operational and mechanical defects only.
Can I disconnect the Cryo Jet from the hose during use?
NO, never disconnect the Cryo Jet from the hose while there is pressure in the line or the valve is in the on position on the Co2 bottle.
Are tools needed before I use this Cryo Jet?
Yes, one crescent wrench or adjustable wrench is needed to connect the hose to the CO, tank.
What kind of tank or bottle do I need?
You need one of two tanks. The most standard of the two tanks needed is a 50 pound high pressure Carbon Dioxide CO, siphon tube tank, also called asiphon 1ank or “Dip Tube Tank. The siphon tank has a tube that drops down the center to the bottom of the tank to dispense the liquid CO,. Make sure you ask for a Siphon tank as a standard CO, tank will not work. The alternative type of tank used is a Dewar tank, which is a larger low pressure refrigerated tank containing much more Co, but at a lower pressure of 350psi or less..
Where can I buy Carbon Dioxide, also called CO,?
You can find CO, gas at a local welding supply shop or Gas supplier (not the gas you put in your car). AIRGAS is a national company which provides CO
How long will the tanks last?
This varies a little on the length of the hose, the length of the blasts and the tank you are using (50 pound elfect High Pressure CO, Siphon or Low Pressure Dewar). The average blast is 2 seconds long, so a High Pres- Sure 50 pound Siphon Tank has 1.5 min of effect and a Low Pressure Dewar Tank has about 10 minutes of
Can CO, cool down an area?
Yes, between 20-35% depending how it is used. A solid stream is colder directly in front than it is towards the outside of the stream of the blast.
What is a good hose length for my Cryo Jet?
The best length for the hose is between 20 feet and 30 feet. Any hose longer than 50 feet will not work as ef feciently as a shorter hose therefore minimizing the output of the effect.
Can I connect multiple hoses or order longer hoses?
Yes. we can custom make any sIze hose with any number of quick connect fittings or standard fittings so you have the future option to shorten or lengthen your hose. We can also create custom hoses for two or more Cryo Jets to run off the same tank or one Cryo Jet to run off multiple tanks. Please email with any inquiries.
How far or how high do the plumes (clouds) of CO, travel when exiting the Cryo Jet?
The CO, plumes will reach at least 20 feet to 30 feet. The humidity in the air directly affects the visibility in re- lation to length and density of the CO, cloud. The more the humidity, the better and farther the white cloud of CO, can be seen.
Is it dangerous to shoot the CO, directly at people?
Yes. CO, displaces oxygen therefore making it very difficult to breath in the immediate path of the CO, plume cloud. Avoid spraying it directly at people who are coser than 6 feet in distance. CO, is also very cold, up to -40 Degrees F. and could easily freeze skin and body parts.

DISCLAIMER: CryoFX.com S not responsible or held liable tor any damages resulting from use of this equipment or any CO, equipment. Ihe equipment listed within is for special effects purposes only and should be used only by pro Tessionals or those wno Tuly understand the use, operation, erfects, and dangers of all equipment listed herein. All equipment should be tested before actual use in front or an audience. Any other use other than what is specified iS prohibited and can cause extreme dangers to anyone in the vicinity. CO, Jets and CO, guns should never be pointed directly at people closer than 5 feet in distance. CO, Jets and CO, Guns should never be pointed at someones face for an extended period of time as Co, displaces oxygen theretore suffocating those in the direct path. Again, we, CryoFX.com are NO responsible or held liable for misuse or damages resulting from the equipment listed herein.