EKO EK5188DG iMira Pro Double Sided Mirror Instruction Manual
- June 3, 2024
- EKO
Table of Contents
EKO EK5188DG iMira Pro Double Sided Mirror Instruction
Prior To Using The Product
Thank you for choosing the
iMira Pro Double Sided Sensor Mirror
Please read these instructions before using the product.
Graphics are for illustrative purposes only.
Product List
Operating Instructions
Micro USB port charging
Please charge the device prior to fi rst time use to ensure sufficient power.
Product can be used while cha rging. Adaptor not included.
- To charge the mirror, connect the USB
TYPE-C side of the cable to the USB port on the back of the mirror, then connect the other side of the cable to any power supply outlet/adaptor with a USB plug.
*Charging time: approximately 4-5 hours for full charge. - Turn on the mirror using the power button.
Tum ON/OFF: Press and ho ld power button for 2-3 seconds.
Product shuts down automatically in low power, please recharge accordingly.
Adjustable Angle
1X/5X Double Sided Mirror
Flip between 2 magnifications, 1X flat mirror and 5X magnified mirror
-
Mirror comes in 1X and 5X magnification.
Simply fl ip the mirror face to switch magnification .- Please do not expose magnified mirror to direct sunlight due to fire hazard.
-
Adjust the mi rror direct ion up and down according to preference.
Mirror angle adjustable up to 50 °.
Oo not use excessive force to adjust the mirror
Sensor ON/OFF
After powered on, mirror automatically lights up when you approach and turns
off when you leave.
-
Sensor on/ Induction light
To use the sensor function, be within the 25-30cm sensor range for product to light up. -
Simply leave the sensor range [40 cm from sensor detection area), and light will automatically turn off after 12 seconds.
Mode Selection
When you need the light to stay on, enter Manual Mode.
After entering this mode, the sensor function will automatically turn off.
Press twice the MODE button for mirror light to stay on !manual model.
Press once MODE button to switch tones.
Setting Brightness
-
Adjusting The Tone
-
Natural:
Simulates natural sunlight for daytime looks. -
Bright:
Cool tone bright light for finer definition of details. -
Warm:
Indoor warm lighting great for evening occasions
-
-
Touch Slide Control
Slide up to increase brightness of the light.
Slide down to decrease the brightness
Light Indicators
Power button blue light | Status |
---|---|
Light up for 2 seconds | Device powered on |
Light flashes once every 2 seconds | Manual mode |
Light stays on | Fully cha ed [when connected to |
ooweronlvl
Power button red light| Status
Light up for 3 seconds| Turn OFF
Light flashes continuously| Low battery
Light flashes once every 3 seconds| Charging
Mode indicator white light| Status
Light stayson| fitandby mode
Liahts off sensor function on)
Flashes for 12 seconds| Counting down to mirror lights auto turn off
Rechargeable Lithium Battery Notice
In case the product is not actively used for an extended amount of time,
please
recharge once every other month to maintain functionality of the lithium
battery.
- Please check local regu lations for disposal of lithium battery powered products.
- Please do not attempt to remove the battery or disassemb le.
Product Packing List
iMira Pro Double Sided Sensor Mirror xl
USB charging cable x1 Cleaning cloth x1 Instructions guide x1
Attention
- Avoid direct contact with sunlight and moisture.
- Use the USB charg ing cable provided with the product .
- Oo not twist the USB cable.
- Do not hit or put excess pressure on the mirror.
- Clean mirror face using the mirror cloth provided, do not spray or rinse with water.
- Kept away from pets.
- Not for use by children without adult supervision.
- Avoid direct contact with heat or placement in high traffic areas.
- Please do not disassemble the product or attempt repa ir. Doing so will void the warranty.
- Recommend use with Voltage 5V/2A power adaptor. Continuous use with other types of power adaptors could cause product to turn off temporarily.
In this case, charge the product full and resume use.
Warranty
Warranty covers electronic components such as chip, electr ical board
and LED mal functions.
Not Covered By The Warranty
- Damages due to user mishandl ing or other than its intended use in a typical household activity .
- Damages due to natural disasters such as fire, earthquake, flood and other Force Majeur events.
- Damages including dents, scratches, and water damage due to transport handled by the user.
- Any modification to the product, including disassembly or attempts to repair by the user.
- All copyr ights belong to EKO.
- We apologize for any inconvenience caused by minor inconsistencies in these instructions, which may occur as a result of product improvement and development.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>