SQT Electronics SK-679AG RF2.4GHz Auto-Link Keyboard Instruction Manual
- June 5, 2024
- SQT Electronics
Table of Contents
SQT Electronics SK-679AG RF2.4GHz Auto-Link
Keyboard
Installing the Batteries
The RF2.4GHz Optical keyboard uses one AAA alkaline battery.
Install the batteries in the keyboard
Step1:
Remove the battery compartment cover on the bottom of the keyboard by
squeezing the cover in from the tab to release it.
Step2:
Insert the batteries as shown inside the battery compartment
Step3:
Replace the cover
Connecting the receiver
The receiver is inserted to a USB port immediately, or by an extra USB cable.
Connect the USB plug to the USB port of your computer.
Multimedia Hotkeys functions:
- received the keyboard does not work:
- Plug the receiver again.
- Please check the keyboard batteries for electricity, watch battery compartments are negative right into the new battery.
- Make the keyboard close to plug the USB receiver within 30 centimeters, if I found the power indicator light flash, the keyboard to match.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions this device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation.