SQT Electronics SK-646BT Bluetooth and 2.4GHz Auto-Link Keyboard Instruction Manual
- June 5, 2024
- SQT Electronics
Table of Contents
SQT Electronics SK-646BT Bluetooth and 2.4GHz Auto-Link Keyboard
Installing the batteries
The RF2.4GHz Optical keyboard use two AAA alkaline battery.
Install the batteries in the keyboard
- Step 1: Remove the battery compartment cover on the bottom of the keyboard by squeezing the cover in from the tab to release it
- Step 2: Insert the batteries as shown inside the battery compartment
- Step 3: Replace the cover
Keyboard instructions
- Bluetooth channel 1 signals
- Bluetooth channel 2 signals
- Bluetooth channel 3 signals
- Low resistance signals
- Bluetooth channel 1 indicator light
- Bluetooth channel 2 indicator light
- Bluetooth channel 3 indicator light
Multimedia Hotkeys functions
SK-646BT Multimedia Hotkeys Functions
System Keys| FN+E(IOS)| FN+Q(Android)| FN+W(Windows)
Esc| Main Page| Main Page| Esc
F1| Clip| Clip| F1
F2| Copy| Copy| F2
F3| Stick| Stick| F3
F4| Language shift| Language shift| F4
F5| Search| Search| F5
F6| Previous Track| Previous Track| F6
F7| Play/Pause| Play/Pause| F7
F8| Next Track| Next Track| F8
F9| Mute| Mute| F9
F10| Voume Down| Voume Down| F10
F11| Volume Up| Volume Up| F11
F12| Lock screen| Lock screen| F12
Press FN+E into IOS (iPad, iPhone) operation system
Press FN+Q into Android (Samsung Galaxy products)operation system
Press FN+W into Windows operation system
Bluetooth Keyboard to use
- Pay attention to the battery is on the cathode,
- According to the channel switch 1 mode, switch to the Bluetooth channel 1 indicator
- Long press the Bluetooth key for 5seconds indicator light flash Bluetooth channel the keyboard into the matching state.
- Open the Bluetooth search switch on Bluetooth devices, search the Bluetooth keyboard
- Double-click the MOFII_888 keyboard icon on the Bluetooth device
- Can be used normally after the connection is successful
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.