COOPER LT56 All-Purpose LED Retrofit Trim Kit User Guide

June 5, 2024
Cooper

COOPER LT56 All-Purpose LED Retrofit Trim Kit User Guide

COOPER LT56 All-Purpose LED Retrofit Trim Kit User
Guide

Phase Control Dimming

LT56 SeleCCTable recessed housing installation.

COOPER LT56 All-Purpose LED Retrofit Trim Kit User Guide - Phase Control
Dimming

COOPER LT56 All-Purpose LED Retrofit Trim Kit User Guide - Download
App

App Store 
Google Play Store

Compatible Dimmers

COOPER LT56 All-Purpose LED Retrofit Trim Kit User Guide - Compatible
Dimmers

For Reference Only

COOPER LT56 All-Purpose LED Retrofit Trim Kit User Guide - For Reference
Only COOPER LT56 All-
Purpose LED Retrofit Trim Kit User Guide - For Reference
Only

Dimmer Notes:

  1. Start time is measured at the lowest dimmer setting.
  2. Some LED dimmers have a “rapid start” design used to provide a momentary power boost to LED and CFL lamps during start-up. When a LED luminaire is on a dimmer with “rapid start” the boost may cause a momentary flash of the LED lighting. This “flash” is generated by the dimmer, and may be more noticeable when the dimmer is at a low setting.

Dimming Guide Disclaimer:

  1. Leviton® is a registered trademark of Leviton Manufacturing Co. Inc.; Lutron® is a registered trademark of Lutron Electronics Co. Inc.; Lightolier® is a registered trademark of Philips Lighting; Hubbell® is a registered trademark of Hubbell Incorporated; Legrand® and Pass & Seymour® are registered trademarks of Legrand®; Eaton® is a registered trademark of Eaton Corporation. These companies and their tradenames, trademarks or brands, where noted, are associated with their respective company and are not associated with Cooper Lighting Solutions. 2) Testing conducted by Cooper Lighting Solutions is not a substitute for and does not imply certification by an independent laboratory or any other standards certification. Refer to the manufacturer specifications for more detailed information on product certifications and standards.
  2. This is a representative list of typical dimmers as tested by Cooper Lighting Solutions for performance with the designated LED luminaires only. Test data contained in this literature is based upon dimmers obtained in the marketplace. Information about these other manufacturers products is obtained from packaging and published information made available by the manufacturer and is deemed to be reliable, but has not been verified. Dimmer performance and perceived limitations of the dimmers are based on factors outside of Cooper Lighting Solutions’ control. The specifications of these dimming controls and their conditions of use may change without notice to Cooper Lighting Solutions or any other user. Cooper Lighting Solutions makes no specific recommendation on product selection and there are no warranties of performance or compatibility implied. Installer must ensure proper local and national electrical codes are followed; and that the dimmer application and condition of use is per dimmer manufacturer instructions and guidelines.

Application Note – H277, H347 and H347200 step-down transformers are qualified to drive multiple Halo LED on a single circuit in Non-IC construction. Installation of these transformers with individual LED fixtures on circuits with multiple LED loads is not recommended. This is not recommended due to resulting multiple inductive currents pulled by each transformer; in this situation the majority of the power would then be reactive (VARS) and not real (WATTS). If H277, H347 or H347200 transformers should be used individually on each LED fixture in a single circuit, then that circuit should be sized for lowered power factor as well as increased apparent power on the circuit. H277, H347 and H347200 are UL/cUL listed for use with Halo recessed housings:H750T, H750TCP, H7T, H7TNB, H7RT.

Step Down Transformers H277 = Steps 277 line voltage down to 120 volts. Attaches to knockout on first fixture’s junction box in a circuit and is 300VA rated. H277 is a UL recognized Component listed under the luminaire UL/cUL listing for Halo Non-IC housings.

H347 and H347200 = Steps 347 line voltage down to 120 volts. Attaches to knockout on first fixture’s junction box in a circuit. H347 is 75VA and H347200 is 200VA rated. H347 is a CSA/UL Listed Component for use under the luminaire UL/cUL listing with Halo Non-IC housings.

Transformer Load – H277 (300VA)

  1. H277 Transformer at full loading consumes a maximum of 16W of power.
  2. When a dimmer or switch is on the secondary (120V) side of the transformer, power is consumed by the transformer when the dimmer or switch is in “OFF” mode at 6.5W and in “ON” mode at 16W maximum under full loading.
  3. When a dimmer or switch is on the primary (277V) side ahead of the transformer, power is consumed only in “ON” mode to a maximum of 16W under full loading. (Use of a dimmer ahead of the transformer is not recommended)

Transformer Load – H347 (75VA)

  1. H347 Transformer at full loading consumes a maximum of 15W of power.
  2. When a dimmer or switch is on the secondary (120V) side of the transformer, power is consumed by the transformer when the dimmer or switch is in “OFF” mode at 2.5W and in “ON” mode at 15W maximum under full loading.
  3. When a switch is on the primary (347V) side ahead of the transformer, power is consumed only in “ON” mode to a maximum of 15W under full loading. (Use of a dimmer ahead of the transformer is not recommended)

Transformer Load – H347200 (200VA)

  1. H347200 Transformer at full loading on 120V side consumes a maximum of 28W of power.
  2. When a dimmer or switch is on the secondary (120V) side of the transformer, power is consumed by the transformer when the dimmer or switch is in “OFF” mode at 9.2W and in “ON” mode at 28W maximum under full loading.
  3. When a switch is on the primary (347V) side ahead of the transformer, power is consumed only in “ON” mode to a maximum of 28W under full loading. When a switch is on the primary (277V) side ahead of the transformer, power is consumed only in “ON” mode to a maximum of 12W under full loading. (Use of a dimmer ahead of the transformer is not recommended)

LT56069FS231EWHR Retrofit LED Downlight Series
(LT56069FS231EWHR Maximum Units on Step Down Transformer Powered Circuits)

COOPER LT56 All-Purpose LED Retrofit Trim Kit User Guide - LT56069FS231EWHR
Retrofit LED Downlight Series

Transformer with Dimmer/Switch on 120V Secondary

COOPER LT56 All-Purpose LED Retrofit Trim Kit User Guide - Transformer with
Dimmer

Transformer with Switch on 277V Primary

COOPER LT56 All-Purpose LED Retrofit Trim Kit User Guide - Transformer with
Switch on 277V Primary

Transformer with Switch on 347V Primary

COOPER LT56 All-Purpose LED Retrofit Trim Kit User Guide - Transformer with
Switch on 347V Primary

Cooper Lighting Solutions 1121 Highway 74 South Peachtree City, GA 30269 P: 770-486-4800 www.cooperlighting.com

© 2021 Cooper Lighting Solutions All Rights Reserved.
Specifications and dimensions subject to change without notice.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Cooper User Manuals

Related Manuals