KOAMTAC KDC270 Charging Adapter Instruction Manual
- June 6, 2024
- KOAMTAC
Table of Contents
KOAMTAC KDC270 Charging Adapter
Follow these same instructions for installing Adaptor with or without Bumper
to charge KDC270 utilizing 4-slot Charging Cradle.
Additional KDC270 Accessories:
- Protective Boot
- Finger Trigger Glove
- Ring Scanner
What’s in the box?
• Charging Cradle
• Adaptor
• Bumper
Installation Instructions
For charging KDC270 with protective boot
- Align ridges on Adaptor with those on Charging Cradle. Insert firmly, until you hear a click. (A,B)
- Insert KDC270 into Charging Cradle with Adaptor, ensuring KOAMTAC logos face same direction. (C,D)
Charging KDC270 with lanyard attached
(with or without protective boot)
If lanyard is connected to KDC270, pull lanyard to back of KDC270 and align
with ridge when inserting KDC270 into cradle. (E,F)
For charging KDC270 without protective boot
- Align the ridges on bumper to the ridges on Adaptor. Insert Bumper into Adaptor until you hear a click. (G,H)
- Insert connected Bumper and Adaptor into the Charging Cradle firmly, until you hear a click. (l,J)
- Insert KDC270 into Charging Cradle with Bumper and Adaptor, ensuring KOAMTAC logos face same direction. (K,L)
Removal Instructions
Remove Adaptor (without bumper) from Charging Cradle utilzing fingers and a
standard (flat-head) screwdriver. (M,N)
Remove Bumper and Adaptor from Charging Cradle using fingers. (0)
Separating Bumper and Adaptor
Place standard (flat-head) screwdriver at bottom of connection point of Bumper
and Adaptor. Push Bumper point in and up, then pull Bumper out of Adaptor.
(P,Q) 
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>