superlightingled DC5-24V Touch Remote Dream Color Double Data Line User Manual
- June 5, 2024
- SuperLightingLED
Table of Contents
superlightingled DC5-24V Touch Remote Dream Color Double Data Line User
Manual
Remote control Instructions
Match code:
- Turn off the 2 bulbs by push switch (not remote control);
- Remove one of the bulbs, then turn on another bulb by push switch , press “group 1 on” once as soon as possible within 3 seconds, the bulb will flash 3 times, this bulb is paired to “group 1” successfully.
- Repeat step 1, put on the other unpaired bulb, then turn on the 2 bulbs by push switch , press “group 2 on” once as soon as possible within 3 seconds, the unpaired bulb will flash 3 times, this bulb is also paired to “group 2” successfully.
Clear code:
- Turn off the 2 bulbs by push switch (not remote control);
- Turn on the 2 bulbs by push switch , within 3 seconds, press “group 1 on” 8 times continuously, the bulb of “group 1” will flash 5 times, code of this bulb is cleared successfully.
- Repeat step 1, remove the cleared bulb, then turn on the other bulb by push switch , within 3 seconds, press “group 2 on” 8 times continuously, the bulb of “group 2” will flash 5 times, code of this bulb is cleared successfully.
FCC WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>