OPT7 90830-01011 Quantum Rock Lights Installation Guide
- June 5, 2024
- OPT7
Table of Contents
90830-01011 Quantum Rock Lights
Installation Guide
QUANTUM ROCK LIGHTS
INSTALL GUIDE
The control wire MUST be connected to a 12V accessory (ACC/ON) fuse tap in
order for the rock light to work properly.
*See step 8 for more details.
Control Box with Accessory Wire x1
WHERE TO INSTALL
RECOMMENDED LOCATIONS FOR ROCK LIGHT PODS
INSTALLATION STEPS
TOOLS REQUIRED
-
5/32-inch Drill Bit
-
7/64-inch Drill Bit
-
Phillips Head Screwdriver
-
Designate your mounting locations for each Rock Light Pod and the control box. (Refer to page 2 for recommended mounting locations)
Avoid hot surfaces and/or moving parts. -
Use a pen to mark the holes where you want to mount the Rock Light Pods. Then, drill a 5/32” hole(s) for the wire connector to pass through.
-
Drill a 7/64” hole for each marked hole.
-
Secure the Rock Light Pods using the included screws. (If mounting on a rounded or uneven surface, utilize the optional rubber mounting pads.)
-
Caution: Rock Light Pods become extremely hot during use – keep away from any vehicle parts that may be damaged by exposure to high temperatures.
-
Connect all Rock Light Pod lines to the control box connectors. Secure by twisting.
-
Connect the red positive line from the control box directly to the vehicle battery.
-
Ground the negative wire from the control box by connecting it to an unpainted area on your vehicle’s frame.
-
Using a fuse tap, connect the 12V control wire from the control box to a power source that turns on ONLY when the key is turned to ACC/ON or a switched fuse position.
-
Some examples of these power sources are radio, dome light or those that are marked as accessories in your owner’s manual or on your fuse box cover diagram.
The kit will not function without this connection.
If you are uncomfortable performing work of this nature yourself, then do not
hesitate to consult a professional for help. Working with a vehicle’s
electrical system can be hazardous to an unqualified individual. OPT7 is not
liable for damages or personal injuries while installing this product. The
installation guide is provided as assistance to reduce setup time.
FULL-SIZE REMOTE CONTROL BUTTON LAYOUT
-
ON & OFF
– Only control “RGB” light (Default color when you first turn it on -> “White/Solid” )
– Need to record the last operation mode and color when you turn it on again -
Dimmer +/-
– Brightness Setting: 50 Levels -
Color Selector
– 20 different solid modes
(See Table 3 for color definitions) -
Independent Control Of White Light
4.1 ON & OFF
– Default color when you first turn it on ->
“White/Solid & Brightness 100%”
4.2 Dimmer +/-
– Brightness Setting: 50 Levels
4.3 Default brightness
– Brightness Setting: 4 Levels
SPECIFICATIONS
Wattage………………………….8W Per Pod
Amp Draw……………………….8A
8 LEDs……………………..Quad-Core CREE
Brightness…………………1,600 Lumens Per Pod
Voltage……………………10-30V
Resistance……………………IP68 Water-Resistant (Pod Only)
Operating Temperature…………………-20°-150°F
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing this product. The Installation Guide is intended as assistance to reduce setup time. OPT7 Lighting assumes no responsibility for improper installation. If you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades, please seek professional assistance.
2 YEAR WARRANTY
NEED HELP?
https://support.opt-7.com/575023-Manual
Scan for troubleshooting tips, and more.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>